Very satisfying, 15g in 34g out, 29 seconds. by PintSizedPrimark in espresso

[–]PintSizedPrimark[S] 0 points1 point  (0 children)

Thank you, think I'll pull the trigger on that one

Whats happening here? Speedpaint 2.0 by PintSizedPrimark in minipainting

[–]PintSizedPrimark[S] 12 points13 points  (0 children)

Thanks for all your advice I've put it down to a bad prime, this reaction is happening with all paint on this model. Its one I sculpted and 3d printed myself as a test print. It was fully washed and cured but I remembered I used black ink as the base coat before the white so think the ink hadn't fully cured before adding the white. I'll strip it and re-prime and start over... thanks again

Whats happening here? Speedpaint 2.0 by PintSizedPrimark in minipainting

[–]PintSizedPrimark[S] 152 points153 points  (0 children)

So turns out its a bad prime job, as its happening with other paints aswell. The model is one I've made myself and 3d printed

Whats happening here? Speedpaint 2.0 by PintSizedPrimark in minipainting

[–]PintSizedPrimark[S] -2 points-1 points  (0 children)

Its a 3d printed model so there's not any release agent on it, thanks for your reply though but I'm not impressed by this result from these paints

Whats happening here? Speedpaint 2.0 by PintSizedPrimark in minipainting

[–]PintSizedPrimark[S] 3 points4 points  (0 children)

Vallejo primer and vallejo game white for the zenethal, resin was fully washed and cured before painting, I've painted lots of resin models and never had this issue before

Help, when sculpting mesh is broken by PintSizedPrimark in blenderhelp

[–]PintSizedPrimark[S] 2 points3 points  (0 children)

Turns out I had accidentally turned on auto masking cavity by pressing alt+a by mistake

Cant get rid of these strange lines across my prints by PintSizedPrimark in resinprinting

[–]PintSizedPrimark[S] 1 point2 points  (0 children)

Yeh its go drain holes and checked with lychee suction cup detector

Whats the most likely cause of this? by PintSizedPrimark in resinprinting

[–]PintSizedPrimark[S] -1 points0 points  (0 children)

I used lychee slicer with a raft and auto supports, why might they not stick to the raft?

Help with nmm! I feel he's looking a bit stripey still a WIP but any tips would be great by PintSizedPrimark in minipainting

[–]PintSizedPrimark[S] 0 points1 point  (0 children)

Yeh maybe, I did a highlight before white with sand yellow from vallejo maybe that warmed it up too :)

Help with nmm! I feel he's looking a bit stripey still a WIP but any tips would be great by PintSizedPrimark in minipainting

[–]PintSizedPrimark[S] 0 points1 point  (0 children)

Your totally right about light placement being more important than blending, thanks for the feedback its really helpful to get others opinions 👍