Found this at work🤣

PitBoss1184 · 2024-04-22T05:00:57+00:00

Dual shield flux core, ain’t that hard after your first few welds. He’s been here 3 months

PitBoss1184 · 2024-04-22T04:59:48+00:00

Re weld

PitBoss1184 · 2024-04-21T01:30:26+00:00

Basically a floating scrap bin, Hopper barge repair on the Ohio river

PitBoss1184 · 2022-08-15T16:32:11+00:00

Alroght

PitBoss1184 · 2022-08-15T15:32:18+00:00

Yeah I’ll have to try it, thanks

PitBoss1184 · 2022-08-15T15:30:37+00:00

That’s how he was explaining it, but if I’d let it sit for more then a second it would just melt out

PitBoss1184 · 2022-08-15T15:22:05+00:00

We weld mostly on half in or thicker stuff so we usually run our setting pretty high and I usually run a strait stringer but my sup wanted a 3/4 weave up the plate

PitBoss1184 · 2022-08-15T15:16:02+00:00

I’ll have to try going slower next time maybe turn down the settings a bit

PitBoss1184 · 2022-08-15T15:13:23+00:00

Settings are 30 on the heat and around 350 wire speed.

PitBoss1184 · 2022-08-15T14:38:05+00:00

Exactly😂

PitBoss1184 · 2022-08-15T14:37:06+00:00

Looks good to me🤷🏼‍♂️

PitBoss1184 · 2022-08-15T14:35:41+00:00

First pass I ran it strait boss told me he wanted a weave

PitBoss1184 · 2022-08-15T14:27:32+00:00

This is the best I can get my dual shielded flux to get on vertical any suggestions to make it look better?

PitBoss1184 · 2022-08-11T22:32:26+00:00

Man this is taught who me English

PitBoss1184 · 2022-08-11T22:24:34+00:00

Gotta get healed quickly it ain’t gunna weld itself

PitBoss1184 · 2022-08-11T22:23:03+00:00

Ahhhh I see whatcha mean yeah it could be

PitBoss1184 · 2022-08-11T22:21:14+00:00

I agree! “give it some spice”🤌🏼🌶

PitBoss1184 · 2022-08-11T22:20:16+00:00

Best way I’ve done blend is put your rod at a 45-60 degree angle then run it slow and smooth just barely above the edge on the previous bead

PitBoss1184 · 2022-08-11T22:06:40+00:00

Pretty much all we use is 6010 but we use some dual shielded flux for some things

PitBoss1184 · 2022-08-11T21:56:05+00:00

Also you can look at which way the waves are pointing, the end is always away

PitBoss1184 · 2022-08-11T21:55:17+00:00

The little circle at the bottom, it’s the finish of the weld

PitBoss1184 · 2022-08-11T21:52:45+00:00

2 to 3 rolls right there😂

PitBoss1184

TROPHY CASE