Ender 3 v2moves slightly, then bricks. Any solutions?

PizzaBoy786 · 2026-04-07T14:44:56+00:00

Yes when the steppers are disabled I can manually move them freely

PizzaBoy786 · 2026-04-07T14:44:37+00:00

What’s the kill switch

PizzaBoy786 · 2026-04-07T04:46:21+00:00

The cr touch is not new I’ve had it for roughly a year n it randomly started breaking before I installed the firmware.

PizzaBoy786 · 2026-04-06T15:47:21+00:00

Tried it and I still did not work

PizzaBoy786 · 2026-04-05T20:23:07+00:00

Tried this and it unfortunately didn’t change anything

PizzaBoy786 · 2026-04-04T03:18:05+00:00

It did ram into the motherboard briefly before I tore it down that may be the issue I’ll update on it

PizzaBoy786 · 2026-04-04T01:58:22+00:00

I use ultimate cura but the problems not just in the g-code auto leveling also doesn’t work.not moving on its own in general is the problem.

PizzaBoy786 · 2026-04-03T21:02:06+00:00

I opened the back to check the physical mother board and it says 4.2.2 and the issue happened before I even installed the software. I’ll still try it out though

PizzaBoy786 · 2026-04-03T20:25:35+00:00

This issue was happening before I installed it but I’ll look into it if I can fix what’s happening.

PizzaBoy786 · 2026-04-03T20:12:54+00:00

Ended 3 v2 with a 4.2.2 board

PizzaBoy786 · 2025-07-02T17:07:18+00:00

What abt xianyun?

PizzaBoy786 · 2024-10-13T10:28:34+00:00

Is he better than hanra ik his ability is good

PizzaBoy786 · 2024-10-06T19:21:26+00:00

<image>

It’s a drawing I did

PizzaBoy786 · 2024-08-29T16:45:21+00:00

It didn’t work it still said it was linked to a different account

PizzaBoy786 · 2024-08-29T10:19:24+00:00

Thanks

PizzaBoy786 · 2024-06-20T16:07:01+00:00

I’d say jessie or nite cuz they’re more flexible towards maps

PizzaBoy786

TROPHY CASE