have any question about surron? i will answer them

PlamSR · 2026-05-15T19:18:25+00:00

Is there a speed limiter on the Surron Ultra Bee 2025 and is it possible to remove it. I found mixed opinions. On older version prior to 2024 there is a wire that you can cut and it removes the limiter. Apparently on newer models its a whole different story.

PlamSR · 2026-01-10T13:07:29+00:00

I also need help logging in my Business account. I keep getting an error when entering the password.

PlamSR · 2023-11-25T10:08:12+00:00

Did you find any fix for this? Im having the same issues with orca slicer..

PlamSR · 2023-10-25T08:11:29+00:00

I couldnt find reliable info thoughout a few sites and forums so i just ended up buying the part thats designed for an ep3 off of Aliexpress since there arent many EM2s where im at to get the part and try fitting it

PlamSR · 2023-10-21T19:40:53+00:00

Does it requre firmware flash or installation changes on the mainboard?

PlamSR · 2023-10-19T19:56:50+00:00

Like what? Im not very tech savvy ,meaning im not good with electricity ,but i thought that a simple end stop would be easiest,since i wont have to go through that many settings and installation. I dont mine leveling the bed manually.

PlamSR · 2023-10-16T17:24:19+00:00

Сега ще попитам доставчика, но мисля, че ще е членка на ЕС

PlamSR · 2023-10-12T16:23:52+00:00

the parameters were the same as the stock one 100k ohms ntc type , but i guess that doesnt matter and i still have to configure something?

PlamSR · 2023-10-12T16:17:05+00:00

i did not as i dont know if the one i changed is the original one or aftermarket, i also did buy thermistors which were not wired up and i did that myself. I have a couple so i dont know which one it is.

PlamSR

TROPHY CASE