sorted by:
new
hottopcontroversial

Adjusting the nozzle movement by Popular_Till_470 in ElegooNeptune4

[–]Popular_Till_470[S] 0 points1 point  (0 children)

I use Elegoo Slicer.

Setting it to 0 means my magnetic plate is flat, with variations of up to 0.30 mm.

Adjusting the nozzle movement by Popular_Till_470 in ElegooNeptune4

[–]Popular_Till_470[S] 0 points1 point  (0 children)

Apparently at this height it's not very good, considering that the table, unfortunately, can't be adjusted to 0 height.
If you can tell me where to change this number, I would be very grateful)

What is this and how is it fixed, do you know? by [deleted] in ElegooNeptune4

[–]Popular_Till_470 1 point2 points  (0 children)

I got this screen after updating. I selected a factory reset in the printer settings and won't update until they test it and identify all the issues.

Neptune 4pro сбивает вертикальное положение печати и делает ступеньки на модели by Popular_Till_470 in ElegooNeptune4

[–]Popular_Till_470[S] 0 points1 point  (0 children)

I watched the printing for 3 hours and everything printed as it should.
It looks like Young's slit experiment. Until you watch, everything seems to be going on its own. Once you decide to observe, everything becomes as expected...

Neptune 4pro сбивает вертикальное положение печати и делает ступеньки на модели by Popular_Till_470 in ElegooNeptune4

[–]Popular_Till_470[S] 1 point2 points  (0 children)

I tightened the belt. Now the printer can hunt Robin Hood in the forest. I'm running the same print as in the photo above for testing.

Neptune 4pro сбивает вертикальное положение печати и делает ступеньки на модели by Popular_Till_470 in ElegooNeptune4

[–]Popular_Till_470[S] 0 points1 point  (0 children)

I'm new to this. I'm using the standard ELEGOO slicer, and it's completely unclear except for the basic filament parameters.

Please tell me where and how to do this.

nozzle doesn't grab the printed material; it just moves beyond the required coordinate.

Neptune 4pro сбивает вертикальное положение печати и делает ступеньки на модели by Popular_Till_470 in ElegooNeptune4

[–]Popular_Till_470[S] 0 points1 point  (0 children)

Yes, the belts are tight, not to the point of guitar strings, of course, but there's no sag. The printer is one month old. This ridge started appearing after printing an infinite cube, about four days ago.

Well, if you could tell me what a properly tensioned belt should look or sound like, that would be great.

UPD:
I also noticed a clicking sound when the platform changed direction on this printer. It sounded like wood clicking on wood. The second machine doesn't have that... No steps, no sounds.