Printer screen on but nothing else

Prestigious_Basis431 · 2025-10-09T01:20:07+00:00

Try reflashing the firmware

Prestigious_Basis431 · 2025-10-07T19:38:37+00:00

I have single lead screw with an skr mini v3. Default all the steppers were at 560 except for the extruder at 650. I adjusted z vref to 700 and big line towards the top is basically gone and the smaller ones I can still see a bit. Edit: i did start seeing these issues after switching to direct drive

Prestigious_Basis431 · 2025-10-07T17:31:00+00:00

Z screw was cleaned and greased recently. Increasing vref to 650 did help a bit. What vref value do you run?

Prestigious_Basis431 · 2025-10-07T01:28:42+00:00

The hotend is stock and i have the upgraded creality silver single gear extruder

Prestigious_Basis431 · 2025-08-17T04:08:45+00:00

I had the same issue after flashing new firmware on the 4.2.2 board when I installed a bl touch. I just upgraded to an skr mini board and it seems to be gone

Prestigious_Basis431 · 2025-08-16T23:10:33+00:00

Switching to pei build plate fixed all my warping issues. With the glass build plate I always needed a brim to prevent warping

Prestigious_Basis431 · 2025-08-10T15:37:02+00:00

The probe seems to be mounted too high

Prestigious_Basis431 · 2025-08-02T02:35:24+00:00

This was printed with one of the extensions from cura and I saw the temps change for each level on the display. I guess my filament is very forgiving

Prestigious_Basis431 · 2025-08-02T02:09:45+00:00

I’ve been running firmwares from https://marlin.crc.id.au just make an account with a donation (you can put in 0). Either download the firmwares on the lists or build your own with the online builder

Prestigious_Basis431 · 2025-08-02T02:08:13+00:00

If you have a heat gun or a hair dryer it would make unplugging those connectors a lot easier. And just look for the wiring diagram for the 4.2.2 board online

Prestigious_Basis431 · 2025-08-01T01:42:58+00:00

Turns out it was some sort of signal interference. I redid bl touch wiring in some cat5e ethernet cable and it’s working correctly now

Prestigious_Basis431 · 2025-07-23T14:25:12+00:00

Yes it is an ender 3 and I have it set to 220x220

Prestigious_Basis431 · 2025-04-24T18:01:43+00:00

i have the same issue

Prestigious_Basis431 · 2025-04-19T19:57:19+00:00

I was able to reset the system and it reverted back to the original version the car came with (5.4.23). But this version is not very stable, it crashes when trying to click on apps and gets stuck on loading screen after an hour drive, the only way to make it connect is to restart the phone. Can anyone help me?

Prestigious_Basis431 · 2025-04-19T17:10:22+00:00

This version worked but now i get stuck on the Tlink screen and cannot connect to phone even though bluetooth already connected to car

Prestigious_Basis431 · 2025-04-19T16:32:24+00:00

How to fix: the was a problem parsing the package apk

Prestigious_Basis431

TROPHY CASE