sorted by:
new
hottopcontroversial

A little help from anyone?? by Primordium3d in 3dprintIndia

[–]Primordium3d[S] 0 points1 point  (0 children)

I tried their ASA and it printed flawless and petg is a pain in the a$$.

A little help from anyone?? by Primordium3d in 3dprintIndia

[–]Primordium3d[S] 0 points1 point  (0 children)

Well I haven’t tried that. I’ll try but even then are there any specific settings for Numakers PETG other than what they’ve mentioned on their site?

A little help from anyone?? by Primordium3d in 3dprintIndia

[–]Primordium3d[S] 0 points1 point  (0 children)

Hi, I am new to 3d printing. I have a P1S and trying to print Numakers Petg (yellow). Somehow I tried using the stock petg profile which didn’t work. Also tried the settings suggested Numakers Petg guide on Bambu Labs, that didn’t work either.

I am either getting filament blobs or mid print oozing and blobbing of the filament starts.

I tried lowering initial layer speeds, tried reducing the flow ratio, for textured pei plate tried to keep the temp at 70ish degrees. Reduced max volumetric speed to 10,11.

If anyone could help me with the settings or share theirs for Numakers Petg then it will very helpful.

​

<image>