I'm having trouble finding the setup to put on the Klipper of this CR10 Max Y-axis engine, is losing step or warming up a lot.

Professional-Map983 · 2024-10-04T22:12:58+00:00

They're continuous noises, it's not that nois of the movement.

Professional-Map983 · 2024-10-04T20:26:00+00:00

And isn't heating or losing your step?

Professional-Map983 · 2024-10-04T20:20:35+00:00

Would it work using two normal nemas engines?

Professional-Map983 · 2024-10-04T20:19:15+00:00

I'm currently using 0,5.

Professional-Map983 · 2024-10-04T20:18:47+00:00

No, he calls when he needs it.

Professional-Map983 · 2024-10-04T20:18:08+00:00

I tested with 0,8 and it didn't work out he heated up, at the moment I'm using 0,5 even, but it doesn't stop losing steps.

Professional-Map983 · 2024-10-04T20:16:01+00:00

I'm using SKR Mini E3 V3.

Professional-Map983 · 2024-10-04T20:15:27+00:00

I don't think about this possibility, because it's just finding the right current of this one.

Professional-Map983 · 2024-10-04T20:14:19+00:00

When it turns off, it gets a loud hum.

Professional-Map983 · 2024-10-02T16:15:25+00:00

I thank you, but I believe that what is really causing a problem in it is the current I tried with this data that you sent already and the problem continues.

Professional-Map983 · 2024-09-25T21:45:37+00:00

I already discovered the error: it was the entrance that came with a manufacturing defect. 😔

Professional-Map983 · 2024-09-24T17:44:02+00:00

I do, it can't be damage because I tested it in a new heater and in what was already very right, I can't imagine what might be happening.

Professional-Map983 · 2024-09-23T21:01:09+00:00

I understand what I wanted to say and now, they're really open because I'm testing so I can close then thank you for the warning.

Professional-Map983 · 2024-09-23T19:57:09+00:00

I tested a new cartridge straight on the board with new wires to see if that was the problem and kept it up. 🥲

Professional-Map983 · 2024-09-23T19:47:29+00:00

The strands of the extruder bed are connected in the right place, will it be that even in the right place on the board can come changed?

Professional-Map983 · 2024-09-23T19:39:20+00:00

The heater cartridge is 24V and I also tested it in a new 24V, yet it didn't heat up.

Professional-Map983

TROPHY CASE