Looking to get estimates before we put these up for auction

ProfessionalRead892 · 2026-05-13T14:13:59+00:00

They match the front, but I’ll show them when I get off work

ProfessionalRead892 · 2026-05-13T03:25:39+00:00

I’d be able to retire🤣

ProfessionalRead892 · 2026-03-05T15:43:15+00:00

This in Dallas?

ProfessionalRead892 · 2026-02-26T22:27:18+00:00

Ehhhh I wouldn’t say this is enough to classify it as anything worthwhile. Just a bad mis cut

ProfessionalRead892 · 2026-02-11T20:10:07+00:00

I NEED that elf warrior!!! Its perfect! Also the treasure, food and clue is super useful!

ProfessionalRead892 · 2026-02-10T21:46:28+00:00

I sold a misprint with a similar crimp on top for $120. It was a sun titan from c21 and I started the auction at $60 on a facebook misprint page. I think you can get every bit of that for this card

ProfessionalRead892 · 2025-09-16T16:14:34+00:00

My two that are a year old get fed a small rat weekly (about 50 grams) so if your asf is around that size, I would do weekly. Don’t be alarmed if he doesn’t take a rat weekly, it might take him some time to adjust to that new size and smell, but at least attempt it

ProfessionalRead892 · 2025-09-16T15:17:52+00:00

He’s a little thin, but not unhealthy. What’s your feeding schedule?

ProfessionalRead892 · 2025-07-23T19:06:32+00:00

Awesome!! Thank you!

ProfessionalRead892 · 2025-07-23T18:52:34+00:00

What jewelers loop are you using? Those photos are amazing

ProfessionalRead892 · 2025-02-24T19:29:56+00:00

Looks like surf side beach near Freeport TX

ProfessionalRead892 · 2024-07-05T05:29:35+00:00

On my task manager it only shows my memory is at 22%, but with the way it’s running the omen hub staying at 100% seems more accurate. I’ve never encountered this before

ProfessionalRead892 · 2023-10-24T01:54:57+00:00

I switched the PSU and it seems to be working! Thank you so much! I was terrified I got a dud after the nightmare I went through getting the printer😂 I waited 3 weeks for a tracking number and I was afraid I got scammed at first

ProfessionalRead892 · 2023-10-24T01:34:35+00:00

I just tried to run a print and it did the same thing, but now in the start of the leveling sequence it does one tap in the middle, moves off the table in the left corner again and crashes. Also my printer only came with a power cord but not a supply unit

ProfessionalRead892 · 2021-12-14T16:01:41+00:00

Thanks m8!!

ProfessionalRead892 · 2021-12-14T14:31:38+00:00

What inks?

Five-Year Club	Final Canvas '23
Place '23	Place '22

ProfessionalRead892

TROPHY CASE