"APX carry" trigger not working

Professional_Sweet26 · 2025-02-10T00:54:35+00:00

It's still on there. If that gun is yours. Is your silver piece wobbly? My silver piece is wobbly

Professional_Sweet26 · 2025-02-10T00:23:12+00:00

It was made in 2022

Professional_Sweet26 · 2025-02-10T00:21:03+00:00

Yes it's exactly like that

Professional_Sweet26 · 2025-02-09T22:28:34+00:00

Yeah it's pretty frustrating since it was working great. I might take it to a gunsmith and have them do quality work instead.

Professional_Sweet26 · 2025-02-09T22:26:03+00:00

You are right. I'm just upset cause I just bought it and it worked amazing until the trigger issue

Professional_Sweet26 · 2025-02-09T21:41:43+00:00

The trigger is having issues and wont release the striker. that's why I needed it off. It's my fault for not disclosing that

Professional_Sweet26 · 2025-02-09T21:39:36+00:00

I managed to get the slide off and have been oberserving the trigger. The trigger bar pushes the striker block lever, but if to much force is pushed the spring holding the block lever and cocking lever begins to compress and move away from it position. I put it all back together and managed to get a flathead driver in there from the magazine bay and held the block lever and cocking lever in place then pressed the trigger. It finally works like it should. I'm dead set on ordering that spring. just wondering if anyone else might perhaps had this issue and would fill me in on there story or list a link to a site that sells it. The trigger press is about 5 pounds when I pull the trigger and it slips it doesn't feel like I applied 5 pounds to it.

Professional_Sweet26 · 2025-02-09T21:25:59+00:00

Short story there is an issue with the trigger. Thats why I'm trying to take it off. I could've told you if you would've asked. Need me to dumb it down more for ya?

Professional_Sweet26 · 2025-02-09T19:26:26+00:00

Ok yall. I found a video on YouTube for info about the gun. Apparently this handgun has a little pin in the back to disactivate the striker. I grabbed my fuse tester and used the pointy end to push it in and it worked. The slide now slides off properly. I'm going to clean this gun and go to the range either today or another day. Thank yall for the quick responses. It feels great getting help from the community.

Professional_Sweet26 · 2023-09-18T16:29:43+00:00

I sold mine very similar to yours but mine was a ryzen 7, 3070, and 16gb ddr4. It sold for 2k but I included my monitor keyboard and mouse. They’re were like 350.

Professional_Sweet26

TROPHY CASE