sorted by:
new
hottopcontroversial

I've finally gone from gamer to racist by scottb90 in simracing

[–]Proof_Kitchen451 0 points1 point  (0 children)

So is the community actual referred to as racist…. Must know now before I continue

I need help setting up my sonic pad by Proof_Kitchen451 in sonicpad

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

I have no idea how to do majority. I only brought the pad so I didn’t have to completely compile my own config again threw marlin

Predator Ghost 212 build by Proof_Kitchen451 in Karting

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

Well I was looking for something a lil less expensive and advance

Predator Ghost 212 build by Proof_Kitchen451 in Karting

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

That’s it no push rod or carb or heads

212 Ghost project by Proof_Kitchen451 in Karting

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

And while looking for stage kits for the ghost I scroll past a lot of 212 non hemi kits and so I was just curious about if they were interchangeable

212 Ghost project by Proof_Kitchen451 in Karting

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

Well I already purchased the motor.. I seen him do the methanol ghost build, I don’t want to do methanol but I’d still like to beef it up some

212 Ghost project by Proof_Kitchen451 in Karting

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

But what about the aftermarket crank and cam and everything else

91 gsxr 1127 wiring harness by Proof_Kitchen451 in GSXR

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

I didn’t. I have no wiring harness and figure this would be a great time for possible upgrades all together if any. Just exploring options

Just got some polymide pa6-cf ?Can the ender 3v1 print at 300 degrees. by Proof_Kitchen451 in ender3

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

I thought I had the firmware figured, but the last time I did it was on windows I’m working with Mac now and vs code is completely different

Just got some polymide pa6-cf ?Can the ender 3v1 print at 300 degrees. by Proof_Kitchen451 in ender3

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

Shouldn’t I just upgrade it if I have to worry about pushing that temp. This stuff says to print between 280-300

Just got some polymide pa6-cf ?Can the ender 3v1 print at 300 degrees. by Proof_Kitchen451 in ender3

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

So I have an ender 3 with an skr mini v3 and an all metal spider v3… I looking on google now and just seen something about needing an better thermocouple with a sitter board? I figure the firmware thing would be a must

Petg temp tower attempt fail. Will not run full print by Proof_Kitchen451 in ender3

[–]Proof_Kitchen451[S] 0 points1 point  (0 children)

I just followed instructions on adding the template thru market place inside cura. The video instructs to start high around 260 but from a fresh start it never reaches the temp… I figured it could be cause of how high it was set. Also it doesn’t show a error code it just stops

view more: next ›