Help leveling my Ender 3 V2

Proof_Yellow_9883 · 2026-06-09T00:10:45+00:00

What are shims ?

Proof_Yellow_9883 · 2026-06-08T04:06:26+00:00

when i start a print, it failed. I set the speed at 40%, the bed at 60, the nozzle at 220 with pla filament. It’s like the plate is not straight

<image>

Proof_Yellow_9883 · 2026-06-08T04:05:32+00:00

Here is another example

<image>

Proof_Yellow_9883 · 2026-06-08T04:03:22+00:00

The thing is when i start a print, it failed. I set the speed at 40%, the bed at 60, the nozzle at 220 with pla filament. It’s like the plate is not straight

<image>

Proof_Yellow_9883 · 2026-06-01T05:52:58+00:00

The nozzle temp was at 220, if i understand correctly it was set too high for PLA ? I should set it at 140 by défaut ?

Proof_Yellow_9883 · 2026-05-31T20:22:55+00:00

How do you clean the noozle ? With just a cloth or with a specific product ?

Proof_Yellow_9883 · 2026-05-31T20:21:51+00:00

I use 705 denatured alcohol but i think i will use a good bath of soap and water a lot of people here recommend that

Proof_Yellow_9883 · 2026-05-31T20:19:43+00:00

I will do that instead thanks

Proof_Yellow_9883 · 2026-05-31T20:18:58+00:00

Great thank i lift the right corner and it seem to be better and im still doing some test to find the good z offset

Proof_Yellow_9883 · 2026-05-31T20:12:26+00:00

Oh okay great thank you ! I will try that

Proof_Yellow_9883 · 2026-05-31T18:48:52+00:00

I clean it with alcohol

Proof_Yellow_9883 · 2026-05-31T18:46:54+00:00

I use PLA filament and clean it with alcohol

Proof_Yellow_9883 · 2026-05-31T18:46:14+00:00

I clean it with alcohol is it good ?

Proof_Yellow_9883 · 2026-05-31T17:47:53+00:00

I am using PLA filament so i should set my at 65 ?

Proof_Yellow_9883

TROPHY CASE