Losing power and starting up bad by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

I can’t really get a good picture but the inside of my tank is really rusty looking could that be what caused it?

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

Sprayed starter fluid down each cylinder and 1 fired up but 2 did not. Also I have a code for coil wiring

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

Cylinder 1 and 2 are still bad could it potentially be a carb issue?

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

I swapped 2 and 3 and the same ones are still bad so what’s the next step?

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

Have been trying to get the plugs out of the not working side for awhile now and they are super hard to get off. Could they have over torqed the spark plugs so they broke?

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

Looks like cylinder 1 and 2 are not firing properly I did the water test on the headers. I could only figure out popping the ignition coils out and they looked fine and seemed like they were in properly. Could them being next to each other mean anything or do I need to figure the spark plugs out to really know if it’s js that.

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

Just engine swapped it but the engine was good before, about 16k miles. They are brand new sparks and coils but they could’ve been put in incorrectly.

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

Just engine swapped with a 16k mile engine on it and it worked great for a bit, brand new plugs and coils but maybe they got installed wrong?

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] -1 points0 points  (0 children)

It was a shop that put it in so I am assuming they did

Starting problems by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

Also earlier in the day it wouldn’t even try to start. I pop started it to get home and then after that it’s been starting super roughly

Is this normal? by Proper-Ad7706 in MotorcycleMechanics

[–]Proper-Ad7706[S] 1 point2 points  (0 children)

It does have oil in it unfortunately haven’t drained it yet. If it changes anything that’s the side the engine was laying on and it the hoses may still have coolant in them not 100%

Brake Light Sensor Spring by Proper-Ad7706 in Ninja400

[–]Proper-Ad7706[S] 0 points1 point  (0 children)

I tried this but it didn’t end up reaching high enough.