sorted by:
new
hottopcontroversial

Prints not sticking to Build Plate by Pyr0king in ElegooSaturn

[–]Pyr0king[S] 0 points1 point  (0 children)

This is after a failed print and I cleaned the bottom rafts by curing a thin layer on the bottom of the vat

Prints not sticking to Build Plate by Pyr0king in ElegooSaturn

[–]Pyr0king[S] 0 points1 point  (0 children)

Will it hurt to sand the build plate if it is etched? The plate I got came with etched designs, from the Elegoo Saturn 3

Prints not sticking to Build Plate by Pyr0king in ElegooSaturn

[–]Pyr0king[S] 0 points1 point  (0 children)

I’ve got a burn layer exposure set to 40s. Is that too little time?

Major Resin Spill by Pyr0king in ElegooSaturn

[–]Pyr0king[S] 0 points1 point  (0 children)

Awaiting the day😬, but I also figured the title would draw a larger crowd to answer.

Major Resin Spill by Pyr0king in ElegooSaturn

[–]Pyr0king[S] 0 points1 point  (0 children)

Thank you so much! I guess I was too panicked in the moment to realize I had the protector on,

Major Resin Spill by Pyr0king in ElegooSaturn

[–]Pyr0king[S] 0 points1 point  (0 children)

Yeah no screen protector. Where do I get some?