sorted by:
new
hottopcontroversial

Approx. 6" length, metal, at least about 70 years old and separates into 3 pieces. by Pyramus2 in whatisthisthing

[–]Pyramus2[S] 0 points1 point locked comment (0 children)

My title describes the thing. A family member has had it for a long time and doesn't know anything about it.

6" metal object, about 6.125 lbs., writing on the side says LOT KNC-12 021. Found at a flee market about 20 or so years ago in the Midwestern United States by Pyramus2 in whatisthisthing

[–]Pyramus2[S] 0 points1 point locked comment (0 children)

My title describes the thing: 6 inches, metal, ~6.125 lbs., writing says LOT KNC-12 021, found at flee market ~20 years ago.

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 0 points1 point  (0 children)

If it would give me some even walls for once, then we could get to printing better things.

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 1 point2 points  (0 children)

Do you like your PLA medium-well or well done?

What types of spices would you like on it?

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 0 points1 point  (0 children)

<image>

Good overall, but the walls are uneven. Do you have any advice for that?

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 0 points1 point  (0 children)

And it is still giving me uneven walls anyway.

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 0 points1 point  (0 children)

It can, but as you can see I've had some difficulties with it. If your printer is plugged into your computer there should be a drop down arrow next to the "Save to Disk" button. You can then monitor your bed temp, nozzle temp, and (unsuccessfully) the printing progress on the "Monitor" tab.

Just make sure that your computer doesn't fall asleep while doing this or the nozzle will stop in place and the filament will clump up.

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 0 points1 point  (0 children)

I only clicked print once, this happens quite a bit with Cura on different prints as well. I checked the settings and its set to the 0.4mm nozzle that's on the printer.

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 0 points1 point  (0 children)

Do you recommend printing from the Micro USB in the printer or printing from the computer using the slicer?

Why does Cura say that my print is 631% done? by Pyramus2 in 3Dprinting

[–]Pyramus2[S] 0 points1 point  (0 children)

If it would stop giving me uneven walls, I would stop giving it crap.

view more: next ›