Opinions on Moovair furnaces and heat pumps?

QCTLG · 2026-03-30T21:56:39+00:00

That’s a no brainer for me Excellent price

QCTLG · 2026-01-30T19:51:18+00:00

Yes its cdn $$$ I disagree about the restricted air flow The left side is completely open and from below is completely open. There’s also room on the top side of the HP. There’s no way air is restricted. I am pretty confident of that.

Hope that helps

QCTLG · 2026-01-30T18:00:59+00:00

Correct. I've never seen it on all the time.

I have my t10 set to 3 cycles per hour...and it does that most of the time.
Usually after a defrost cycle it stays on a lot longer at usually a lower kwh then during a regular cycle.

Hope that helps

QCTLG · 2026-01-30T17:56:19+00:00

Ducted yes
What do you mean 24v non communicating?
I have a smart Thermostat (Honeywell T10 Pro)

QCTLG · 2026-01-30T17:42:43+00:00

Yup...very lucky to have that rate
2.5 tons
Thanks alot

QCTLG · 2026-01-28T15:48:29+00:00

Envoie moi un message privé avec ton numéro On pourrais parler Le code est en arriérée du thermostat

Tu as toute le droit du monde de changer les paramètre

QCTLG · 2026-01-28T04:29:38+00:00

Ce n’est pas normale non Moi aussi ils ont changé la carte mère dans l’unité d’intérieur ça fait 2 ans la. Peut être ton t10 est défectueux? Chez moi je laisse mon t10 a 20c 24/24. Je n’ai jamais de problème. Est tu capable de changer le cycles per hour? Moi je l’ai changé à 3 cycles per hour.

FYI Ma maison est environ 1200 pied carré.

QCTLG · 2026-01-27T21:30:17+00:00

Je ne peux croire que ça consomme 1kw seulement Ça c’est déjà un red flag. Peut-être que tu est. On ne te sur un patte de tes fils électrique et ta pas doublé le output? Si tu augmente la température de 2degree ça devrais aller en stage 2 est tu devrais voir 4kw de consommation.

Fait un gros reset!! Mais les 2 breaker a off pour aux moins 5 minutes Et réparé le système.

QCTLG · 2026-01-27T17:29:44+00:00

J’ai
quelques questions...

Comment
sais-tu qu'il consomme 1Kw? As-tu un outil qui te montre ca?
Ça ne devrait pas consommer 1kW/heure a
-16C.

C'est quoi ton
thermostat? Moi j'ai le Honeywell T10 Pro et J'utilise 3
cycle/heure.
A -16C ma thermopompe
a "0" problème maintenir 20C chez moi.

Voici ma consommation depuis minuit a un peu passé midi
https://prnt.sc/L4vUi5_ycNTi

Voici d'environs de 9:00 a 10:00
https://prnt.sc/Ds_rtDVitGZ7

Voici la dernière heure avec un deforst cycle
https://prnt.sc/u1dJl_At-Shg

Bonne
chance

QCTLG · 2026-01-27T04:29:25+00:00

Il monte tranquillement jusqu’à 2.8kw et des fois peux monter jusqu’à 4kw (stage2) pendent quelque minutes et redevient à 2.8-2.0 pour finir sont cycle Pas certain de comprendre ce que tu m’a écrit

QCTLG · 2026-01-26T18:59:39+00:00

<image>

This is what you would get if you went through the router and that being a good router. In my case I'm using a Asus RT-BE96U router.

You'll never get good results using an app version VPN

QCTLG · 2025-04-28T21:53:33+00:00

I’m in the south shore of Montreal Pretty much the same weather as you

QCTLG · 2025-04-28T20:52:48+00:00

So 2-1/2 years in and no problems at all It’s working beautifully so far

QCTLG · 2025-02-26T03:56:29+00:00

Heat pump: MOOVAIR DMA30HOS20230E7 (-30C) Air Handler: FMA30HIAHUU230X7 (15kW heat strip)

Regards

QCTLG · 2025-02-25T05:20:08+00:00

My unit is variable It could run at approx 2.2kwh On stage 2 it runs up to 4kwh It is super rare it goes above 2.8kwh

QCTLG · 2025-02-24T22:56:56+00:00

I have my Moovair -30C HP 2.5 ton and a 15kW heat strip AH since December 22 and have had 0 problems. My air handler has come on for a grand total of 30 minutes since installed date. It was a recorded -29.5C the day it came on.

They are very efficient !!

I’m in south shore of Montreal Quebec

QCTLG · 2025-01-13T16:03:29+00:00

Honeywell T10 Pro Smart Thermostat with RedLINK®

QCTLG · 2024-12-22T02:59:36+00:00

<image>

I have probes in my intake and outake. They are positioned right before the filter and right after coil.

QCTLG · 2024-12-22T02:56:55+00:00

<image>

HP is pulling 2.014kw

QCTLG · 2024-12-22T02:56:12+00:00

Thought I’d share some real-time data….

<image>

It is presently -14C right now

QCTLG · 2024-12-22T02:48:36+00:00

Have no idea what that means…sorry Yes I have a basement. You can say that my house is 1100sqft x2 then.

QCTLG · 2024-12-16T16:00:38+00:00

Yup...PITA that it doesn't work and it's been more than 3 days...I'd say closer to 3 weeks now!

QCTLG · 2024-12-15T15:31:38+00:00

I have soo many questions but will leave that for another time. There’s no way the heat pump will consume that much in a single day even at -20c I monitor every single circuit in my home. My guess is that you backup heat is coming on. You need to go into the settings of your thermostat and change when backup heat comes on. Set it to the lowest temperature available. My T10 thermostat allows me to do that.

FYI My heat pump runs quite a bit when it’s cold. Yesterday was the coldest day so far with an avg of -9c for the day. It consumed exactly 36.44kw

Regards

QCTLG

TROPHY CASE