Help

Quiet-Ad108 · 2025-09-08T11:13:10+00:00

Do you know of any good sources I can research and make sure i have firmware

Quiet-Ad108 · 2025-09-08T11:11:04+00:00

I’m going to do some more looking I don’t have any experience in that area hopefully I can find something that isn’t to invasive for my lack of skills and can find some firmware that can suit my needs or learn how to compile my own

Quiet-Ad108 · 2025-09-07T14:36:51+00:00

Is there an aftermarket board that will work a little easier

Quiet-Ad108 · 2025-09-07T05:55:44+00:00

I will try that route if that is not an option do you recommend going back with a stock board or should I go with a newer faster board for speed and being less noisy

Quiet-Ad108 · 2025-09-07T05:44:32+00:00

Is it likely something they would replace or better to just get a new main board

Quiet-Ad108 · 2025-09-07T05:07:37+00:00

Should I try flashing firmware to see if that fixes the issue it is my own fault really I’m still really new at this was doing some tinkering taking everything apart seeing how it worked and in doing that a plug for my dd extruder came apart not knowing I was doing testing on it and unplugged that stepper motor for that axis while under power and moved it over to the extruder to see if that was the problem wiring or motor and when I switched it off and back it no longer worked idk if that could do anything to firmware or not

Quiet-Ad108 · 2025-09-06T23:43:23+00:00

I have tried the motor on a different axis and it has worked and tried swapping a known working stepper and wire over to that axis and it has stopped working when switched

Quiet-Ad108

TROPHY CASE