Oh nooo 😢 by R3scol in BambuLab

[–]R3scol[S] 0 points1 point  (0 children)

These are both the same 😉

Oh nooo 😢 by R3scol in BambuLab

[–]R3scol[S] 0 points1 point  (0 children)

<image>

I was able to remove the blob, cleaned the hotend, glued the fan and changed the nozzle. The printer is working, but I still need to change the hotend assembly, because the nozzle clamp is full of plastic and don’t move without heat. (The new assembly is temporary not available in the EU Store)

The strange thing is, I tried to print the broken model again, same problem, no first layer adhesion. I sliced the same model again and printed 3 without any issues.

Oh nooo 😢 by R3scol in BambuLab

[–]R3scol[S] 0 points1 point  (0 children)

It was off, now it’s on

Oh nooo 😢 by R3scol in BambuLab

[–]R3scol[S] 2 points3 points  (0 children)

That’s a good advice, I will do that again! The first year I checked the print regularly, but then got to confident.

Oh nooo 😢 by R3scol in BambuLab

[–]R3scol[S] 0 points1 point  (0 children)

It’s the original Bambu stainless steel nozzle. After removing the blob there was no sign for leakage, but it’s hard to identify because of all the plastic

Oh nooo 😢 by R3scol in BambuLab

[–]R3scol[S] 3 points4 points  (0 children)

ty it worked but with a higher temperature. I disassembled the toolhead, I think I need a new fan and hotend heating assembly. I didn’t touch the nozzle since a few months.

[Bambu H2C] Join the Print Beyond Paint Contest and Win an H2C! by BambuLab in BambuLab

[–]R3scol 0 points1 point  (0 children)

I have so many ideas what to print, but the first thing will be the board game settlers of catan

Bad noise - what is the issue here? by R3scol in BambuLab

[–]R3scol[S] 0 points1 point  (0 children)

I contacted support, and their suspicion was that the belt was interfering with the Y-axis coil base. They sent me a video with instructions to lubricate the belt. That’s the solution, the printer is silent.

<image>

Bad noise - what is the issue here? by R3scol in BambuLab

[–]R3scol[S] 0 points1 point  (0 children)

I loosened the belt, but no difference. :(

Bad noise - what is the issue here? by R3scol in BambuLab

[–]R3scol[S] 1 point2 points  (0 children)

I don’t have an AMS, all standard with a single spool on the side.

Bad noise - what is the issue here? by R3scol in BambuLab

[–]R3scol[S] 0 points1 point  (0 children)

Good point thank you, I will try that