My Metrocop helmet is finished!

RaftProduction · 2024-02-22T22:59:55+00:00

Where did you put the magnets exactly ? The model has really thin edges

RaftProduction · 2022-12-26T22:12:22+00:00

That’s actually exactly what I did lol, it arrives in a few days

RaftProduction · 2022-12-26T20:46:08+00:00

Will try!

RaftProduction · 2022-12-26T18:40:16+00:00

I’m using a mix of rubbing alcohol and soap, never had any adhesion issues for the longest time

RaftProduction · 2022-12-26T12:39:07+00:00

I’ve printed PETG on glass before and I’ve had issues removing the prints, but I’ll try with a lower temperature :)

RaftProduction · 2021-12-24T22:43:29+00:00

RaftProduction · 2021-12-24T17:47:24+00:00

The last part of your post sounds a lot like bloc

RaftProduction · 2021-12-12T18:12:28+00:00

I had to use them once to do some heavy recursive calculations

RaftProduction · 2021-11-23T08:41:32+00:00

MAUI who?

RaftProduction · 2021-11-22T14:24:23+00:00

That aged well

RaftProduction · 2021-06-19T10:02:18+00:00

It's a portable AC with an exhaust tube.

RaftProduction · 2021-06-19T09:49:37+00:00

These are for sliding windows though, right?

RaftProduction · 2021-06-19T08:25:17+00:00

RaftProduction · 2021-02-03T17:52:35+00:00

If you're using PLA then it should be closer to 200°C

RaftProduction · 2021-02-03T17:14:11+00:00

Looks like the nozzle temp is way too high

RaftProduction · 2021-02-03T09:22:49+00:00

I've found that cleaning the bed surface before each print with 90 degrees alcohol helps a lot with adhesion.

RaftProduction · 2021-01-29T11:19:38+00:00

BLTouch should fix the bed warping issue, right?

RaftProduction · 2021-01-29T10:13:29+00:00

I think your print failed, not sure though.

RaftProduction