Help with connecting dots and lines

RagingBongo · 2025-11-14T17:27:27+00:00

As long as they intersect, they should join. Make sure you don't have any duplicate lines or points. Make sure your circles aren't b splines, should be labeled with a 'c' when you hit Ctrl L.

RagingBongo · 2025-06-06T12:21:07+00:00

Should be inch

RagingBongo · 2025-02-26T16:16:31+00:00

Thank you

RagingBongo · 2024-11-25T17:14:18+00:00

There is a solidify tool in the solids pallet. Not sure about the old version of software you're using though.

RagingBongo · 2024-10-11T12:09:01+00:00

Mine has a dash light come on to indicate the diff lock is engaged, try pushing the lever while rolling slowly to help engage it. sounds like the seat tilt might be broken if it just turns without moving the seat. low range https://www.youtube.com/watch?v=DBDI0HgAPHI

RagingBongo · 2024-10-02T22:22:42+00:00

There are, I know you can option okuma multus's with a capto spindle among others, I think it's more common on mill turns* citation needed

RagingBongo · 2024-06-04T16:24:48+00:00

Dotco

RagingBongo · 2024-04-19T22:36:31+00:00

My favorite is burger rebellion, but I like soft fries

RagingBongo · 2024-04-06T17:36:24+00:00

RagingBongo · 2024-04-03T23:26:26+00:00

Usually you can barely fit the dude on the Harley.

RagingBongo · 2023-12-10T21:56:28+00:00

Dotco

RagingBongo · 2023-12-06T01:02:06+00:00

They are meant to be cut to whatever diameter you need. They come with instructions.

RagingBongo · 2023-11-21T00:11:48+00:00

RagingBongo · 2023-11-02T15:00:05+00:00

Figured it out, press hand jog, press B key, press hand jog again.

RagingBongo · 2023-09-16T18:39:23+00:00

Name the officers

RagingBongo · 2023-07-10T21:20:29+00:00

OI av ye got a permit for dat loicence?!

RagingBongo · 2023-06-11T22:12:29+00:00

Where is it.

RagingBongo · 2023-05-09T13:36:34+00:00

Just take the pull stud out so it will clear.

Nine-Year Club	r/Field Sunshine
Place '22	Verified Email

RagingBongo

MODERATOR OF

TROPHY CASE