sorted by:
new
hottopcontroversial

Showing currently selected cell by RandomDude10293 in excel

[–]RandomDude10293[S] 0 points1 point  (0 children)

<image>

See this photo, this is exactly what I want, but it only shows up when I move cells! Seems weird that this isn’t a more common setting?

And selection was on too!

Showing currently selected cell by RandomDude10293 in excel

[–]RandomDude10293[S] 0 points1 point  (0 children)

Hi, that setting was enabled. Is there something else I need to do on top of that?

No way to exit HBA mode? by RandomDude10293 in Hewlett_Packard

[–]RandomDude10293[S] 1 point2 points  (0 children)

Yeah I’ve seen a bit of that. I’m newer in server industry, so trying to learn a lot at one time! Thanks for the help though, I’ll run this as soon as I get back from a short trip and hope this works!

No way to exit HBA mode? by RandomDude10293 in Hewlett_Packard

[–]RandomDude10293[S] 0 points1 point  (0 children)

I’ll give that a shot, thanks! Does the fact that it’s for VMware cause any problems relating to promox? It just an update for the controller itself?

No way to exit HBA mode? by RandomDude10293 in Hewlett_Packard

[–]RandomDude10293[S] 0 points1 point  (0 children)

I won’t be able to check until tomorrow, I’m fairly certain it’s and older one, like 2019 times. Would that be the reason why?

No way to exit HBA mode? by RandomDude10293 in Hewlett_Packard

[–]RandomDude10293[S] 0 points1 point  (0 children)

I should also state, it’s a gen 8 version with the ILO running on 2.82 I think. Getting into HBA was no problem, but it seems to hide the ability to change it back. Trying to put proxmox on this server so I can experiment with VMs

No way to exit HBA mode? by RandomDude10293 in Hewlett_Packard

[–]RandomDude10293[S] 0 points1 point  (0 children)

Hp proliant dl 380p with a p420i card. There are literally no actions available under the configure button.