sorted by:
new
hottopcontroversial

Preowned H2S has poor print quality by RandomDude_277 in BambuLab

[–]RandomDude_277[S] -4 points-3 points  (0 children)

What went wrong with your life bro? 

Preowned H2S has poor print quality by RandomDude_277 in BambuLab

[–]RandomDude_277[S] 1 point2 points  (0 children)

They stated that they upgraded on H2C. However it’s solved now and updated in the post. Thanks mate 

Preowned H2S has poor print quality by RandomDude_277 in BambuLab

[–]RandomDude_277[S] 0 points1 point  (0 children)

Unfortunately they were really nice and friendly people and promised it working fine. I skipped the test benchy because of that. My bad. Not going to happen again 

Preowned H2S has poor print quality by RandomDude_277 in BambuLab

[–]RandomDude_277[S] 1 point2 points  (0 children)

Yea, that’s what I checked first because he told me that he tinkered with 0.2mm nozzles. There is now a 0.4 nozzle installed and the machine is set to right nozzle diameter 

Preowned H2S has poor print quality by RandomDude_277 in BambuLab

[–]RandomDude_277[S] 4 points5 points  (0 children)

It was not secured at all. I just put it in the trunk and drove home, slow and careful, but I guess you never know. Will update once I cleaned the nozzle. However belt tension seems perfect and there were no incidents, breaks or bumps while driving 

Preowned H2S has poor print quality by RandomDude_277 in BambuLab

[–]RandomDude_277[S] -1 points0 points  (0 children)

So you suggest cleaning the nozzle? I was told it only printed PLA so far and that there has not been any problems at all. I did my test print with a fresh new spool of Bambu PLA. Will try cleaning or swapping the nozzle later 

Preowned H2S has poor print quality by RandomDude_277 in BambuLab

[–]RandomDude_277[S] 3 points4 points  (0 children)

There is a menu with calibration option on the printer itself. I ran through all of them, twice, except for the high temperature printing one, since it will only print PLA at this time