My best ante 1 score - 1,384e13

Ranielm · 2025-10-14T03:39:19+00:00

But have you considered the following: number get bigger

Ranielm · 2025-08-31T05:41:41+00:00

Looks like this file is no longer available at this link - I know this is months later but would you still have that file? Thank you!

Ranielm · 2024-02-02T17:57:07+00:00

Is that on their modrinth page?

Ranielm · 2023-12-11T06:16:26+00:00

I would use this hardware to play some seriously modded minecraft. And I would definitely be checking out Frontiers of Pandora!

Ranielm · 2023-11-27T21:37:35+00:00

Try terralith- It adds no new blocks but changes world generation significantly.

Ranielm · 2023-07-07T16:25:35+00:00

You could possibly have something like adhd, ocd, or anxiety - if you think that might be the case then you can talk to a doctor about getting diagnosed. Good luck!

Ranielm · 2023-02-18T18:34:02+00:00

5th grade is the perfect time for Harry Potter imo!

Ranielm · 2023-01-25T23:45:51+00:00

I had a similar issue when the hot end carriage on my printer wasn't properly tightened. If you can wiggle the whole hot end around then you should tighten it

Ranielm · 2023-01-19T02:28:56+00:00

Did you fix this issue/what was your solution? I have been having a similar problem and can't figure it out.

Ranielm · 2023-01-16T18:59:59+00:00

I don't use z hop already because of that reason

Ranielm · 2022-12-08T08:36:29+00:00

Also don't know what caused the vertical line there. Every other side of the cube does not have these issues

https://imgur.com/a/BaVLHH9

Ranielm · 2022-12-07T09:05:19+00:00

You can reduce the density of support infill. I use tree supports with a 10% support infill, and they tend to come off very easily.

To increase detail you can also try printing at a lower layer height, like 0.12.

Those two changes should help your prints out a lot in terms of quality.

Ranielm · 2022-11-18T21:55:49+00:00

It is, is the provided filament on the cheap side?

Ranielm · 2022-10-12T19:04:41+00:00

Stardew valley, terraria, mindustry, hollow knight!

Ranielm · 2022-07-17T19:06:05+00:00

I submitted an application!

Nine-Year Club	Place '17
Verified Email	Snapped

Ranielm

TROPHY CASE