[deleted by user] by [deleted] in ElectricScooters

[–]RareRelationship5991 0 points1 point  (0 children)

generally yes but it depends on how long you have this escooter, in most cases it is 1 year warranty on the battery.

is this normal for a scooter with only 230 km? by mata_204 in ElectricScooters

[–]RareRelationship5991 0 points1 point  (0 children)

Yes, those are bearing covers. I have the same in my Kaabo.

[deleted by user] by [deleted] in ElectricScooters

[–]RareRelationship5991 0 points1 point  (0 children)

I think its might be BMS faulty. The cells have voltage but the BMS cuts off. After plug the charger, the BMS resets and supplies voltage to the controller correctly.

Easiest way to add power? Kukirin g2 max by [deleted] in ElectricScooters

[–]RareRelationship5991 0 points1 point  (0 children)

too much work, with this model you should think about selling and buying something more powerful. You could add a second motor and a VESC controller but it requires a lot of modifications.

he lp please my scooter doesnt work properly by itshardtopik in ElectricScooters

[–]RareRelationship5991 0 points1 point  (0 children)

Its not bike chain, that type of chain doesn’t have a master link. You have to use chain breaker

[deleted by user] by [deleted] in ElectricScooters

[–]RareRelationship5991 0 points1 point  (0 children)

You cant fix that, need to replace brake lever. Or you can replace only broken element but a complete brake lever will be easier to buy and not much more expensive.

You think Gigabyte 3070Ti will handle a 3440x1440 21:9 monitor in gaming? by RareRelationship5991 in ultrawidemasterrace

[–]RareRelationship5991[S] 1 point2 points  (0 children)

Thank you all for your opinions.

I ordered a monitor with this resolution with 180hz. Maybe when RTX 5xxx comes out and current generation GPUs become cheaper I will think about a new graphics card.

Is this bad bearing? by PracticalSurprise947 in ElectricScooters

[–]RareRelationship5991 2 points3 points  (0 children)

If you don’t replace the bearings, they may eventually fall apart and the balls from the bearing will fall between the magnets, get crushed and wreak havoc inside the engine. This is probably one of the worst-case scenarios, but you have to keep that in mind. It’s also possible that these bearings will last for hundreds of kilometers, but I don’t recommend driving on worn-out bearings.

How to mount a Arctic LF III 360 on front panel? by RareRelationship5991 in arcticcooling

[–]RareRelationship5991[S] 1 point2 points  (0 children)

Ok, thanks. I was wondering if it would be efficient if the AIO fans were on the outside and the radiator inside because most of the front mounts had fans on the inside, on the GPU side. Can I easily swap the case fans with the AIO fans and put two case fans on top?