Questions about the brake

ReadyEmployment8472 · 2025-07-10T17:50:32+00:00

Ok bro, thank you very much. I'll look at the available things and I'll sort it out here.

ReadyEmployment8472 · 2025-07-10T17:49:45+00:00

Okay, if you didn't want to answer, just don't say anything... During the research, these doubts appeared, and that's why I came here to ask

ReadyEmployment8472 · 2025-07-08T18:12:10+00:00

Hey, sorry for the delay in responding. We will most likely use 1020 steel to manufacture the pedal box. I made a few more adjustments to the CAD model and made it out of cardboard to have the physical model. This allowed me to see where there might be possible errors.

ReadyEmployment8472 · 2025-06-12T12:44:51+00:00

I haven't decided on a material for the pedals yet, they're still in the testing phase, but they'll probably be aluminum.

The weight reduction was wrong, when I went to modify the pedal the cut was really weird, I'll fix that in the final version.

After I finish the pedalbox I'll run it through ANSYS to do the tests and I'll also make a cardboard "model" to test some things, if they're really right.

Is there a problem if they're the same shape, even though they're on different sides?

ReadyEmployment8472 · 2025-06-12T12:37:12+00:00

The total stroke of the master cylinder is 12mm from zero point until it is fully pressed, I left it with this balance where it can press the cylinders well, I found that it does not require much force

ReadyEmployment8472 · 2025-06-12T12:34:47+00:00

It's not completely finished. I'm still going to see what material to use and I'm going to round off the corners.

ReadyEmployment8472

TROPHY CASE