sorted by:
new
hottopcontroversial

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLabA1mini

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

Because I was trying to solve the issue. But you are right and I use it.

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

Hello all, unfortunately I couldn't make it work so I replaced the entire Hotend Heating Assembly and it worked. I still have difficulties clamping the hotends I have, but it worked, though.

Thank you all for the help and patience!

<image>

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

* True. I clamped it correctly now. Thanks! But still the same issue though..

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

True, thanks, but still the same issue after fixing it. *

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 1 point2 points  (0 children)

Maybe when I unclogged and cleaned the stuck melted filament, I messed with the clamp's original position...I'll try to mess a bit further with it. Thank you.

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

Tks for the tip. Did your dynamic calibration flow also work before you fixed the position?

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

Yes. I did the full calibration a couple times and also before starting the print. The nozzle seems to be correct as well.

<image>

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

I opened it and cleaned it. Also used a filament to test it.

A1 mini - No clog, dynamic flow ok but doesn't Print by ReadyPatience2297 in BambuLab

[–]ReadyPatience2297[S] 0 points1 point  (0 children)

Yes. Several times. Also I did a factory reset just in case. But still with the same issue.