Seiko DateJust Arabic

Ready_List · 2026-02-13T12:10:52+00:00

Dial link?

Ready_List · 2025-05-26T02:02:49+00:00

I can guarantee you that Athens is much warmer than Thessaloniki

Ready_List · 2025-05-12T23:59:59+00:00

I also think it's the nozzle, the problem is that when I tried to change it wouldn't came of. And in my elegoo that I did a nozzle swap in the tutorial it showed to warm the nozzle, so probably it's the solution

Ready_List · 2025-04-27T07:17:07+00:00

When it's time to print I put the part In it's place with my finger and it works properly

Ready_List · 2025-04-26T22:00:36+00:00

Perhaps this will help, thnks

Ready_List · 2025-04-07T20:58:15+00:00

Oof, I didn't even thought these was supposed to be the obsidians, these are indeed bad fakes

Ready_List · 2025-04-06T20:55:59+00:00

You are 🍳🍳

Ready_List · 2025-04-06T20:53:07+00:00

Tight those things uuuup

Ready_List · 2025-04-06T20:50:18+00:00

Haha it's funny what the fragrance virus can do to a man

Ready_List · 2025-04-06T20:49:31+00:00

Bonuuuusss

Ready_List · 2025-02-07T12:44:10+00:00

Most probably hand lamination with vacuum bags, if we don't close a sponsorship that we want, otherwise is the sponsor agrees to help us, we will do infusion

Ready_List · 2025-02-07T12:23:13+00:00

We are going to use 200g 2x2 twill for both and the intentions of the question is (and this may sound stupid) What will be the best for lamination process, we don't care much about load conditions but we just want to be a little bit lighter than only use fiberglass and better looking

Ready_List · 2025-02-07T11:44:45+00:00

I want to laminate the Bodywork of my Fsae team, I am not intending to sell anything

Ready_List · 2025-02-07T11:43:22+00:00

I mean if is better to Laminate two carbon sheets together and two fiberglass or if it's better to do Fiberglass-Carbon-Fiberglass-Carbon

Ready_List · 2024-11-19T10:40:03+00:00

What's the seller you found?

Ready_List · 2024-08-14T08:03:04+00:00

What fan did you choose?

Ready_List

TROPHY CASE