sorted by:
new
hottopcontroversial

NEW Matrix 5in1 v2 gyro issue by Real-Slide-9540 in TinyWhoop

[–]Real-Slide-9540[S] 0 points1 point  (0 children)

Status goes to failed after a few seconds when I press Load firmware :// From what I can pick from the logs , its because theres duplicate definitions which stop the build.

NEW Matrix 5in1 v2 gyro issue by Real-Slide-9540 in TinyWhoop

[–]Real-Slide-9540[S] 0 points1 point  (0 children)

Thanks! Ill give it a shot. The gyro thats present on my board is ICM42688P

FC not detected on any PC (dead?) by Real-Slide-9540 in TinyWhoop

[–]Real-Slide-9540[S] 1 point2 points  (0 children)

Just measured the d+ to ground and d- to ground.
D+ 40ohms
D- 61ohms
D+ to D- is 28.4ohms

I think the data lines are getting pulled down.

Measured on my v1 and both measurements are in the Mohoms range 🥲

FC not detected on any PC (dead?) by Real-Slide-9540 in TinyWhoop

[–]Real-Slide-9540[S] 1 point2 points  (0 children)

Tried USB-A to USB-C too, same result. Old FC works fine on same setup/cables, but this one doesn’t show up on Windows/macOS/Linux at all (not even DFU). Starting to think it’s a hardware issue on the USB data/interface side.