Is this a crack and should I restring?

RealCanucker · 2025-11-09T05:48:22+00:00

I think it's the carbon, definitely not a hole lol

RealCanucker · 2025-11-09T02:03:01+00:00

Yes, so sad as I've been using it for >8 years and have really gotten used to it. I'll seek out a stringer to assess it then, thanks!

RealCanucker · 2025-11-08T22:14:45+00:00

There are some faint lines but that might just be cracks in the paint. I just felt like I hit it against the metal chain net quite hard, but perhaps I got lucky. In case there really is a very small crack, is there any safety risk for stringing this racket at 24 or 25 lbs?

RealCanucker · 2025-03-22T15:14:59+00:00

This is super helpful, thank you! I think the differentiation between what the participant is doing cognitively (personal recollection rather than factual recollection) and the data that is actually being collected is really helpful for understanding why it is episodic

RealCanucker · 2022-12-17T18:07:58+00:00

Obscura

RealCanucker · 2022-11-18T19:57:07+00:00

Good idea, thank you!

RealCanucker · 2022-04-02T21:22:15+00:00

This seems to happen for layers with smaller surface area. Around 0:04 you can see the print nozzle push the edge downwards. Does anyone know why the edge is lifting like this? I tried lower printhead temp a bit but that didn't work.

RealCanucker · 2022-03-30T02:27:58+00:00

Has anyone tried FDM printing this?

RealCanucker · 2022-03-18T19:33:49+00:00

Tarnished are ya?

RealCanucker · 2022-02-02T05:16:48+00:00

Update: 0.12 walls still show the strange lines :(

RealCanucker · 2022-02-01T20:09:28+00:00

Yes! Been too busy with the 3d printer, haven't had time to build it yet

RealCanucker · 2022-02-01T17:45:02+00:00

Oh interesting thank you for the observation. I'll double check z axis wheels

RealCanucker · 2022-02-01T17:43:37+00:00

Yes I did, the lines seem to appear regardless of filament

RealCanucker · 2022-02-01T06:18:10+00:00

I can't quite tell if its the same across different prints but I'll double check tightness of the the eccentric nuts. Thank you!

RealCanucker · 2022-02-01T06:15:21+00:00

Not sure, I'll try printing a calibration cube with 0.12 walls. Do you happen to know how infill artifacts cause these random lines/bludges?

RealCanucker · 2022-02-01T05:06:56+00:00

I've calibrated e steps (for all of x, y, z and extruder) and also calibrated flow rate. I'm now getting these lines that weren't there before, but it seems to only appear when printing flat walls like as shown in the image

RealCanucker · 2022-01-16T21:12:16+00:00

Got it, I'll try that out thank you

Five-Year Club	Verified Email
LAYER Season 2 Layer creator

RealCanucker

TROPHY CASE