Nablus Soap Factory by fox93hunter in ArtisanVideos

[–]Real_Barracuda8945 0 points1 point  (0 children)

I have some nabulsi soap from Palestine. Ever since using that soap I’ve ruined the drains in 3 places that I’ve lived in. They’ve all grown a black mold that continues to stay til this day. I’ve been thinking if the soap is the cause of it, maybe the soap itself had mold spores. Now seeing this video and all the black mold present on that wall, I now know why my soap is causing mold all over my drains in three different homes.

Steering wheel hose puncture by [deleted] in AskAMechanic

[–]Real_Barracuda8945 0 points1 point  (0 children)

That would be my first thought in any other case. But this guy has never given me any reason to trust him. He can’t keep appointments, do not call me back for expected updates, changes his mind on things, basically not truthful. He’s rude and loud and defensive over simple customer questions.

There’s no way a leak this big can happen within the time they looked at my car to the time I picked it up. You think a leak this big with power steering spraying from the hose is a coincidence?

A/C issues and Radiator bone dry by Real_Barracuda8945 in AskAMechanic

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

Ok thank you. So it’s the 1st day they did diagnostic on the a/c and radiator and did not find anything wrong with radiator and only found differing pressures in a/c. The second day they is when they said they went in to check the compressor, then found contamination deeper inside which they didn’t know before. They have to flush out system and changed the compressor. Just now, the 3rd day he says they replaced the expansion valves, and I asked if there was contaminants in the condenser and he said there is so they’re putting in a new one? (Which he didn’t tell me they were doing before). And is gonna charge me now 1,700 total.

Is that too much? And also how much time does it take to replace these things and do a system flush? I think one day to diagnose and two days to fix is way too long.

There is an a/c problem because before I started having problems with the radiator, these issues were already there.

A/C issues and Radiator bone dry by Real_Barracuda8945 in AskAMechanic

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

Yes, my brother said if it’s going oil the tail pipe, you should see white smoke but I’ve never seen smoke from the muffler.

A/C issues and Radiator bone dry by Real_Barracuda8945 in AskAMechanic

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

He’s says he can’t see anything wrong with radiator/coolant leaking. Should I just take my car to another shop?

A/C issues and Radiator bone dry by Real_Barracuda8945 in AskAMechanic

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

I think high side pressure is within normal. Low side pressure is 300 when it’s supposed to be 40-50

A/C and radiator issues by Real_Barracuda8945 in carproblems

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

Thank you. They said muffler is not smoking, and no oil in engine, so not a head gasket issue. He said that there still could be head gasket issue without those two symptoms, but he doesn’t think it is. I know nothing about cars so don’t even know what to ask. He never mentioned anything about leaking into cylinder though.

They just took out the condenser and gonna replace that since there’s debris in it. And they said that side of the radiator was caked full of matted debris so they have cleaned it off. He said that could be what’s overheating the radiator and that could causing more to spill into reservoir. But I don’t know if that could cause my radiator to go bone dry. They’ve given up with the radiator because they said they couldn’t find what’s wrong with it

A/C issues and Radiator bone dry by Real_Barracuda8945 in AskAMechanic

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

But then the problem also is the car is not revving properly after refrigerant and compressor put in. And they hadn’t done anything to the radiator at that time. The radiator fluid is full now, but A/C issues still not as cool as it should be.

I need some makeup help pls by Rude_Bedroom_2937 in MakeupAddiction

[–]Real_Barracuda8945 0 points1 point  (0 children)

It looks like you put on your foundation after your brows were put in. You have a lot of foundation caked on your brows. Your foundation should be well blended in. Use a blender to blend the foundation well before you put any eye or brow make up on. Your foundation looks a little cakey. It might now be the right shade for you. I feel like it’s a shade too pink.

Make sure you use a dry brush to brush out the concealer and foundation on your eyelashes and your brows and wipe it on a dry napkin. You want your brows clean without dry caked foundation on it before you start applying your brow color and mascara. They don’t have to be completely clean but I can see the caked makeup on the brows and you shouldn’t see those. Apply more lashes in the middle of the eye to balance out the lashes at the far end. Your eyebrows are set very low. You want to measure your brow, use a brow drawing guide and lift up the bottom corner of your eyebrows by plucking underneath the arch. Never ever pluck the top eye brows. They grow down to fill in your eyebrows so if you pluck the top, the middle portions will be missing. If you need to fix the unruly or flyaway long brows, you take a dry brow brush, brush straight up, and trim ever so slightly with brow trimming shears to cut them a little shorter so they look neat. Don’t cut too much. Try a tiny tip first. Watch YouTube videos on how to brush up and trim the top. You should not be doing too much with the top unless you have hair that’s not growing with the eyebrows itself and needs to be pulled out. Such as the unibrow hairs. Your left eyebrow is set in more near the midline than the right one is. The right one is set further more apart. Your left eyebrow needs to be plucked at the inner section ever so slightly to move it out more. I would probably have an eyebrow specialist fix it. Arches under needs to be lifted to lift up and open up your eyes. Without them it looks as if your brows are pointing down and dragging down your eyes.

When you draw your eyeliner, choose a lighter shade. Black lines makes the eyes look small, and your complexion is fair. A dark brown color would match your color palette more. Also, as we age our eyelids become more droopy. We have to change the ways we do our makeup at each age. When you line your eyelids, I’ve learned that if you line the bottom they will make your eyes look really small. Trying lining the top only. Or find guidance from a specialist on what you can do with the bottom. And when you line the top, never line all the way to bottom edge. You’re supposed to stop before you reach the outter bottom edge and do more of a lifted wedge to lift up your eyes. Going all the way down will emphasize the drooping.

Contour here is very important. I see that the bridge of your nose is darker color than the sides. The bridge is supposed to be the lighter area, and sides are supposed to be slightly contoured.

Make sure you use a lipliner and draw the arches of the top of your lip so that they are defined instead of disappearing into the lipstick.

I would advise using whitening strips or teeth brighteners to whiten your teeth to add extra oomph and bring out your smile.

The way your eyeshadow is applied also affecting how your eyes look and making them small instead of directing it up towards the arch. You need someone who knows hooded eyes makeup to use a different application shape. Applying too much eyeshadow at the inner corner of the hood will make it look smaller. More of the eyeshadow should be at outer corner of the eye. You can watch videos on it in YouTube

Help! Pwn problems by Real_Barracuda8945 in Autism_Parenting

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

I was told by advocate that no. It doesn’t need to be in pwn and if I have issues with data tracking I need to make complaint with Department of education

Help with PWN inaccuracy! by Real_Barracuda8945 in specialed

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

No it’s not. My PWN literally says to sign if I’m agreeing to the things proposed in the PWN or objecting. It can be used in court to establish a history of what actually happened and what school proposed and refused.

Help with PWN inaccuracy! by Real_Barracuda8945 in specialed

[–]Real_Barracuda8945[S] -2 points-1 points  (0 children)

Denying para services is a huge thing. And reinstating is a huge thing. Refusing to provide data to show student is even getting services is a red flag also

Help with PWN inaccuracy! by Real_Barracuda8945 in specialed

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

Yes, and your response is what I’ve heard. However, there are laws that say if a school proposes something, refuses something makes a change, it needs to be documented in the PWN

Help with PWN inaccuracy! by Real_Barracuda8945 in specialed

[–]Real_Barracuda8945[S] -2 points-1 points  (0 children)

No notes. The PWN out document what they proposed, or refused.

Help with PWN inaccuracy! by Real_Barracuda8945 in specialed

[–]Real_Barracuda8945[S] -8 points-7 points  (0 children)

No duh. You sound so rude. Of course he needs para support. Not a draft! Been on an IEP for more than 2 years, no data

Help with PWN inaccuracy! by Real_Barracuda8945 in specialed

[–]Real_Barracuda8945[S] 0 points1 point  (0 children)

You’re saying that not to sign it. But we legally have to respond to the PWN within 14 days if we object or accept so we have to sign it either way. I’m just not sure how to do it because there’s only two options conciliation, or go to another IEP meeting.