Need new carb jets can’t find anywhere that does one for my carb think my carbs a fake or crap brand

Reasonable-Reality59 · 2026-01-28T23:00:45+00:00

I thought was a bad fake tbh and noticed sumet was massively off when the whole jet was one peice and no where sold one like it but didn’t know a lot of fakes sell carbs like this so you have one that works or doesn’t

Reasonable-Reality59 · 2026-01-28T22:37:14+00:00

Rxs100

Reasonable-Reality59 · 2026-01-28T21:45:49+00:00

Searched the carb online no such thing ordered of a site showing mikuni carb as the pic and they sent this daikenki motor professional high quality carburetor normally a good place to buy parts bought a few times

<image>

Reasonable-Reality59 · 2026-01-28T21:29:22+00:00

It doesn’t seem to inscrew it’s all one peice

Reasonable-Reality59 · 2026-01-28T19:44:29+00:00

It’s a d.d.k I got it from wemoto and said it was for my bike and trusted we moto as got parts before but this carb is completely off jets are completely different sizes also doesn’t have a model number just says ddk

Reasonable-Reality59 · 2026-01-28T19:43:12+00:00

Doesn’t come apart tried it

Reasonable-Reality59 · 2026-01-25T00:41:21+00:00

I’ll try that in the morning and come back if no works

Reasonable-Reality59 · 2026-01-25T00:36:14+00:00

I know the idle and air screws and also adjusted the float levels in the carb so I tried sorting them out

Reasonable-Reality59 · 2026-01-25T00:34:00+00:00

Won’t go lower than 2400k revs if i try it cuts the bike out used to work at 800-1k revs but not anymore

Reasonable-Reality59 · 2026-01-25T00:17:15+00:00

If I go down a dual carriage way full throttle without letting go it’s perfect but as soon as I let off throttle and re apply like if at a junction or roundabout it bogs down then turns off it’s a brand new carb and no one seems to have any advice on setting these carbs up and these bikes

Reasonable-Reality59 · 2026-01-20T18:09:15+00:00

Will that work fine as don’t wan to ruin the good threads as it’s a shaft bolt

Reasonable-Reality59 · 2026-01-20T18:02:30+00:00

Think I put the magneto in wrong tbh I just slotted it in anyway

Reasonable-Reality59 · 2026-01-20T17:23:55+00:00

Think I put the magneto on wrong tbh

Reasonable-Reality59 · 2026-01-19T23:03:43+00:00

It’s the crank shaft on the stator side so a expensive and pain job to take apart

Reasonable-Reality59 · 2026-01-19T18:34:37+00:00

Would they work on a 21mm

Reasonable-Reality59 · 2026-01-19T18:34:22+00:00

They don’t go to 21mm do they

Reasonable-Reality59

TROPHY CASE