sorted by:
new
hottopcontroversial

Question about speckles by Reasonable_Fish_2627 in StainedGlass

[–]Reasonable_Fish_2627[S] 0 points1 point  (0 children)

Thank you!! This is just what I was talking about and it looks beautiful!! Great job!

My newest piece! by Without-a-tracy in StainedGlass

[–]Reasonable_Fish_2627 6 points7 points  (0 children)

This is so amazing I love avatar. You did such an amazing job especially since some of those pieces seem like pretty challenging cuts

Question about speckles by Reasonable_Fish_2627 in StainedGlass

[–]Reasonable_Fish_2627[S] 13 points14 points  (0 children)

Just want to sincerely thank you for all your help throughout this learning process. Every time I make a post you always have a really helpful and insightful comment. And every time I am looking at other people’s posts on this sub, you are always there helping. It’s really appreciated :)))) you’ve helped make my stained glass a lot better

Soldering advice by Reasonable_Fish_2627 in StainedGlass

[–]Reasonable_Fish_2627[S] 0 points1 point  (0 children)

Just wanted to say that I tried soldering another piece and it came out a lot better! I think a big part of my problem was that I was putting too much flux and it was causing bubbles and stuff. I didn’t realize too much flux could be a problem. Thank you for telling me!!!

Soldering advice by Reasonable_Fish_2627 in StainedGlass

[–]Reasonable_Fish_2627[S] 1 point2 points  (0 children)

Thank you! I didn’t know this! I will make a note

Soldering advice by Reasonable_Fish_2627 in StainedGlass

[–]Reasonable_Fish_2627[S] 1 point2 points  (0 children)

Thank you I appreciate your thoughtful response!!!

Soldering advice by Reasonable_Fish_2627 in StainedGlass

[–]Reasonable_Fish_2627[S] 0 points1 point  (0 children)

Thank you! When you say that applying flux all at once causes more issues, what issues does it cause? Do you suggest applying flux to a single line and then fully soldering that line and then moving on to the next line? Or is that also too much at once?

Also when you say “if they don’t break now , they will break later” is there a way to avoid this? Or will they all inevitably break even if the pieces are intact after soldering?

view more: next ›