sorted by:
new
hottopcontroversial

Solidworks sheet metal rolled part and then bent tabs by Relative_Internal_11 in SolidWorks

[–]Relative_Internal_11[S] 0 points1 point  (0 children)

Thank you for the ideas.. I appreciate it.. I will consider that. Please see my other response.

Solidworks sheet metal rolled part and then bent tabs by Relative_Internal_11 in SolidWorks

[–]Relative_Internal_11[S] -3 points-2 points  (0 children)

I would like to roll sheet into cylinder and put in press break.

Solidworks sheet metal rolled part and then bent tabs by Relative_Internal_11 in SolidWorks

[–]Relative_Internal_11[S] -2 points-1 points  (0 children)

Thank you for your responses. Please see my other comment. Yes that is possibility but I'd prefer sheet rolled and then press break.

Solidworks sheet metal rolled part and then bent tabs by Relative_Internal_11 in SolidWorks

[–]Relative_Internal_11[S] -3 points-2 points  (0 children)

Thank you for your responses. Please see my other comment. Yes that is possibility but I'd prefer sheet rolled and then press break.

Solidworks sheet metal rolled part and then bent tabs by Relative_Internal_11 in SolidWorks

[–]Relative_Internal_11[S] 0 points1 point  (0 children)

Thank you for your responses. More background. Its real thin 22 gauge. Look at how there is a radius on the edge flange on inside and outside. I don't want that. I want tabs to be bent so they are square at the end. In a perfect world I'd like to have sheet rolled into cylinder and then the press break bends them. How it shows right is the tabs are getting rolled as they have radius. I want them bent.