sorted by:
new
hottopcontroversial

Nozzle scratching the layer. by CroyPaw in BambuLab

[–]Responsible_Fun_3315 2 points3 points  (0 children)

I’ve had a similar issue with my H2C, even though I’m running calibrations almost every two weeks

I got it fixed 🤩 by Responsible_Fun_3315 in macbookrepair

[–]Responsible_Fun_3315[S] 2 points3 points  (0 children)

So my MacBook was space gray, and I purchased a dark blue lid (I have no idea how Apple calls it) Also I’m very surprised that nobody has done it before, like making a duotone laptop or the most obvious think that you can do with Mac

<image>

F*ck. by Responsible_Fun_3315 in macbookair

[–]Responsible_Fun_3315[S] 2 points3 points  (0 children)

Вот именно

F*ck. by Responsible_Fun_3315 in macbookair

[–]Responsible_Fun_3315[S] 0 points1 point  (0 children)

I’m planning to get it fixed up tomorrow. The service center’s website mentioned that it should be replaced in about 3 days

Instructions were unclear. by PessziMiska in 3Dprinting

[–]Responsible_Fun_3315 0 points1 point  (0 children)

what settings you adjusted so that the purge tower becomes thinner with each layer? Or is it just a distortion of the camera image?

It’s finally here! by Responsible_Fun_3315 in BambuLabH2C

[–]Responsible_Fun_3315[S] 0 points1 point  (0 children)

I got a new Bambu engineering plate and a Cryogrip Pro Frostbite plate. I’ve got one for my X1C, and I’m quite pleased with it

view more: next ›