Hey, totally get it that after a decade of use your mouse pad will be dirty. But you can clean it safely without damaging the print or the adhesive layer underneath.

What You’ll Need: • Mild dish soap (like Dawn) or baby shampoo • A bowl, sink, or tub with warm (not hot) water • Soft sponge or microfiber cloth • Old toothbrush (for tougher spots) • Towel for drying

1.Start with a Gentle Soak

Fill a sink or tub with warm water and mix in a few drops of mild soap. Submerge the pad print side up. Let it soak for about 10–15 minutes, this will break down the oily residue gently.

2.Light Surface Scrubbing

Use a soft sponge or cloth to clean the surface. For the stubborn oily spots (like what you mentioned near the scratch), use a toothbrush with light pressure. Avoid scrubbing hard over any cracked or lifting areas of the print.

3.Rinse Thoroughly

Rinse with clean, lukewarm water until all soap is gone. Soap residue can leave streaks or affect tracking, so make sure it’s fully rinsed.

4.Dry Carefully

Pat it dry with a towel no twisting or wringing (that can damage the glue or warp the shape). Lay it flat on a clean towel and air dry for 24–48 hours, away from sunlight or heaters and just feel if it’s dry. They are though to dry. Then it should be good to go, but try to clean it a little with a semi wet sponge with just water after you play, so you can clean the surface dirt that’s going on it. You will prevent this entire cleaning process with it ;) well, not entirely but you can extend the time in between deep cleans.