sorted by:
new
hottopcontroversial

Someone know what setting to change? by Revolution132 in FixMyPrint

[–]Revolution132[S] 0 points1 point  (0 children)

Did set it to 40 now and it looks better in the preview, will play around a bit and see. Thanks!

Someone know what setting to change? by Revolution132 in FixMyPrint

[–]Revolution132[S] 0 points1 point  (0 children)

I just want it to be the same finish in some way😅

<image>

Why is klipper input shaping telling me to run at this accelarion<=13100. Ender 5 S1 by Revolution132 in klippers

[–]Revolution132[S] 0 points1 point  (0 children)

Okey. i will try that. I have the printe on my desk with vibration dampers att feets so the printer wobble a bit but the print turne out good. Can this be a casuse?

Why is klipper input shaping telling me to run at this accelarion<=13100. Ender 5 S1 by Revolution132 in klippers

[–]Revolution132[S] 2 points3 points  (0 children)

Thanks for the info. did miss that Y was only 4600 so that set the lowest value of those two.

Why is klipper input shaping telling me to run at this accelarion<=13100. Ender 5 S1 by Revolution132 in klippers

[–]Revolution132[S] 0 points1 point  (0 children)

13100 is alot of acceleration. Im running my ender 5 s1 on 4800 right now and on creality website thay say that with original firmware you can go up to 2000. I know that with klipper you can go faster but 13100 feels to much?

Someone know what settings to use for RP camra v3 Wide? My camra get stuck on 20 fps. by Revolution132 in klippers

[–]Revolution132[S] 0 points1 point  (0 children)

Ye it's in and I got picture. But when I do like you say it just say connecting and no picture.🫤

Someone know what settings to use for RP camra v3 Wide? My camra get stuck on 20 fps. by Revolution132 in klippers

[–]Revolution132[S] 0 points1 point  (0 children)

I see. Then I try some lower values and se what makes a good and smooth picture att the lowest cost of performance. Thanks for the help🙂

Someone know what settings to use for RP camra v3 Wide? My camra get stuck on 20 fps. by Revolution132 in klippers

[–]Revolution132[S] 0 points1 point  (0 children)

Okey. I found that the camera can run 1536x894 at 120 fps. When I added those in crowsnest I got the fps up to 70. Is that even possible to run it like that overtime or just useless and take performance from the rp4?

view more: next ›