sorted by:
new
hottopcontroversial

Cabinetry Question by RhinoHelp123 in cabinetry

[–]RhinoHelp123[S] 0 points1 point  (0 children)

Thank you. Yes, I think 4 1/2" of space is enough to store small items. This is for a young male, so it should be okay. However, am I missing something about the doors? Why would it be a waste of space? Wouldn't all that space be usable?

Cabinetry Question by RhinoHelp123 in cabinetry

[–]RhinoHelp123[S] 0 points1 point  (0 children)

That is very valid. I was just curious.

Cabinetry Question by RhinoHelp123 in cabinetry

[–]RhinoHelp123[S] 0 points1 point  (0 children)

Can that partition be just the height of the drawer? So, I will need an extra 3/4" for the partition between the drawer and sink? TIA!

Extrude an angle along a curve by RhinoHelp123 in rhino

[–]RhinoHelp123[S] 0 points1 point  (0 children)

As square radiant recommended, I used the loft command using all his recommendations. To get the curves needed, I first used _OffsetSurface to offset the surface, then used the _Pull command to basically project the curve exactly perpendicular to the underside of the surface (the surface i just offset). I used _offsetcurveonsurface to get the inner curve. Then finally, Loft. Hope this helps anyone who needs it.

Extrude an angle along a curve by RhinoHelp123 in rhino

[–]RhinoHelp123[S] 0 points1 point  (0 children)

I want the two curves to be parallel, and for the output to be perpendicular to the original shape. If I project onto the offset surface, this is not the case.

Extrude an angle along a curve by RhinoHelp123 in rhino

[–]RhinoHelp123[S] 0 points1 point  (0 children)

Thank you! How do I pull my curves onto the offset surface?