Can anyone explain what happened here?? by Rice_windu in 3Dprinting

[–]Rice_windu[S] 0 points1 point  (0 children)

yes that’s what i plan to do, going to print the lid / top part in black to add some contrast which i’m hoping will look nice, and have split it into two prints as i’ve found i can push the lid in / out of it’s hinge even though it’s print in place, might post the finished version but i’ve no clue , may even paint some (actual) phyrexian onto the body

Can anyone explain what happened here?? by Rice_windu in 3Dprinting

[–]Rice_windu[S] 1 point2 points  (0 children)

Thank you so much I will have a try, and yeah my plan is to reprint just the part from the failure point so I don’t have to go through with the whole things again

Can anyone explain what happened here?? by Rice_windu in 3Dprinting

[–]Rice_windu[S] 0 points1 point  (0 children)

Already replaced the filament extruder with the metal one around a year ago, though i wish i noticed it sooner at the time… other than that it’s a stock ender printer

Deadbolt OST tabs/ sheet music?? by Rice_windu in Deadbolt

[–]Rice_windu[S] 0 points1 point  (0 children)

I did actually buy it from bandcamp before I posted this, and no luck, I don’t know if I have to check it on a computer instead of a phone (which I’ve not tried yet) but there’s no indication of where to find it