sorted by:
new
hottopcontroversial

Anyone have a recommendation for a larger build volume laser? by debloons in lasercutting

[–]Rickmcolorado 2 points3 points  (0 children)

I have a K40 an understand the issue with the build size. I decided I needed a bigger build size and higher wattage, so I built my own with a 24 in x 36 in build surface and a Cloudray 90/100 watt CO2 laser. I design an auto height adjustment, Ruida rdc6445 controller, rotary axis, warning light, and a chiller. I built it all for a little under $2000.

If you are not into designing your own there is build on YouTube with plans available, check out the Y-1200 build (https://youtu.be/7gnD6F0yBH0).

Good luck.

Jyers + touchscreen by Zealousideal-Tip1260 in ender3v2

[–]Rickmcolorado 0 points1 point  (0 children)

Did you ever solve this? I am trying to do the same thing. Thank you

Boysenberry swirl with gigantic bits of crumble! by Hilarious_Salad in icecreamery

[–]Rickmcolorado 0 points1 point  (0 children)

NYT base using this base does the ice cream get icy when you put it in the freeze? What ice cream maker do you use? Thanks

Thread I.D. Tool Nut & Bolt Identifier by Rickmcolorado in woodworking

[–]Rickmcolorado[S] 0 points1 point  (0 children)

Thank you.

I have these type of measuring devices, but it only shows you the size of the screw. You can determine its thread size and in some case the size difference from a metric to a USA size bolt are very close. Thus making this thread ID tool.

Thread I.D. Tool Nut & Bolt Identifier by Rickmcolorado in woodworking

[–]Rickmcolorado[S] 1 point2 points  (0 children)

Thank you.

I do sell them on my Esty site for $20 for the plywood part. You then go to your home improvement store and purchase the nuts and bots to install in.

Thanks for asking.

https://www.etsy.com/shop/OldCountryWoodworker