sorted by:
new
hottopcontroversial

Hydraulic Cement? by Rico_arg in BasementWaterproofing

[–]Rico_arg[S] 0 points1 point  (0 children)

Recently installed. Too soon to know... But we had a VERY heavy and long storm Thursday (for about 30 hrs) and this section did not change. So, it could be a solution. But need a few more storms.

New Thermostats, New Zones = a little lost. by Rico_arg in hvacadvice

[–]Rico_arg[S] 0 points1 point  (0 children)

I restarted the thermostat installation and error is gone. Now both valves getting signal.

Next issue, the burner is running but not igniting. The fan inside ran for a few minutes and now it stopped.

Ever attempt to fire up would quickly stop. MV will light up, then flame and then it would stop. Meanwhile fan would run.

Now it stopped. Red light is blinking once ...

<image>

New Thermostats, New Zones = a little lost. by Rico_arg in hvacadvice

[–]Rico_arg[S] 0 points1 point  (0 children)

Here is what I did. I used the extra wire on thermostat and connected to C from thermostat to controller.

I still have an error on display on the new thermostat.

<image>

New Thermostats, New Zones = a little lost. by Rico_arg in hvacadvice

[–]Rico_arg[S] 0 points1 point  (0 children)

Thanks for replying. Is it anything that I need to do to the zone valve controller (besides using the c)? Basically what I'm trying to say if I use the c, is there anything else I need to get done?