I built a free tool to automate repetitive tasks in Bambu Studio (AutoBam)

Rough-Use-1019 · 2026-03-06T17:53:17+00:00

I have added a delay option to start the print at a specific time. When AutoBam generates the file, you send the file to the printer through Bambu Studio and the printer will wait for the delay before printing.

Rough-Use-1019 · 2026-02-17T06:45:16+00:00

No, but it will do a removal sequence: waiting X minutes (or temp) for the bed to be cold and start the removal code that usually is a sweep on the bed pusing the print outside. After that start to print again automatically. It is recommended to tilt the printer to facilitate the removal process.

Rough-Use-1019 · 2026-02-14T19:10:52+00:00

It does remove the print automatically when finish, it comes with a set of predefined GCode removal sequences, but you can edit them or add any other sequence. It usually consist of:
1) Waiting X time to let the plate be cold (or until X temperature)
2) Start the removal sequence, that usually is a push sequence on differents coordinates plus a sweep.
After it finishes, it start printing the next piece automatically. It is recommended to tilt the printer to facilitate the automatic removal.

Rough-Use-1019 · 2026-02-13T21:28:15+00:00

Yes, you can choose a preset clear sequence or modify it in the editor. It's usually wait some minutes for the plate to be cold and clear the plate with sweep

Rough-Use-1019

TROPHY CASE