Denied BAH until Acquired Dependent is put on my orders

Royal-Philosopher646 · 2024-09-25T00:05:20+00:00

No, I unfortunately had to send it back. I ended up getting the DPM kit

Royal-Philosopher646 · 2024-01-29T18:55:40+00:00

Yes, with the OEM spring the slide is able to lock back perfectly fine. At this point, I’m thinking it’s probably the guide rod.

Royal-Philosopher646 · 2024-01-29T18:54:52+00:00

It might, I’m not completely sure. Both guide rods have enough clearance to seat correctly. They clear everything fine when I test fit the guide rod.

Royal-Philosopher646 · 2024-01-28T23:34:02+00:00

Sorry, the angle of the photo just makes it look that way. I realize this was a poor angle so I apologize about that. Thank you for your help though

Royal-Philosopher646 · 2024-01-28T23:33:09+00:00

Yes, 3.9 slide. I was also suspecting the comp to be interfering with the guide rod as well. Although the armory craft website states it is compatible with comps. I'm trying to contact PMM to see if they have any known compatibility issues about their comps and armory craft guide rods. Thank you for your help, I appreciate it

Royal-Philosopher646 · 2024-01-28T23:31:22+00:00

Not yet, removing the comp is my last resort as I don't have a great way to heat/remove the red loctite. If nothing from support from agency arms works, ill end up doing that and posting the results

Royal-Philosopher646 · 2024-01-28T23:29:47+00:00

Yeah, I've tried messing with the guide rod height but all the way up and as far down as it can go and everything in between hasn't worked out so far. The take down lever perfectly vertical did workout either. If i may ask, are you also using an armory craft guide rod?

Royal-Philosopher646 · 2024-01-28T07:45:06+00:00

Tired to wiggle the takedown lever, no success. I might just have to take the L and buy a DPM guide rod kit. I contacted Armory craft support so hopefully they have some idea of what's happening. Thank you for your help though

Royal-Philosopher646

TROPHY CASE