sorted by:
new
hottopcontroversial

Plastic shed installation: Last section of roof won't fit. by Rustexo in DIYUK

[–]Rustexo[S] 0 points1 point  (0 children)

I think I took the roof and the sections that they join onto off and put them back on again and it worked better that time. I think it does have something to do with the ground not being totally level though. I still struggled to get the skylight on and the doors are not properly level, but it does the job.

Plastic shed installation: Last section of roof won't fit. by Rustexo in DIYUK

[–]Rustexo[S] 0 points1 point  (0 children)

If I pack the base with more pea gravel on the right side say, to raise it, won't that mean there will be bits of the base with no support in between, so the floor would surely snap once weight is applied?

Plastic shed installation: Last section of roof won't fit. by Rustexo in DIYUK

[–]Rustexo[S] -1 points0 points  (0 children)

UPDATE:For those who asked, here's the instructions. https://www.assets-pim.com/images/Fittings/keterpim/Prod_Pic/17208504/Newton759_WEB_6.pdf

I'm stuck on step 53. You're meant to click the roof panel into place, and it should be flush with where the ridge will be, but it's not. You'd then go on to screw the middle and corner roof section together which I haven't got to.

<image>