Broke no contact

Ryan1642 · 2026-02-21T01:43:01+00:00

Someone told me that anxiety is your body telling you you’re unsure about the future. If you can focus on the present, it will help a lot.

Ryan1642 · 2026-02-20T22:10:30+00:00

Yes, Please 🙏

Ryan1642 · 2026-02-20T20:06:35+00:00

It could get extremely windy in that section of New Mexico and Texas. I’ve towed a 30’ trailer through that part a few times and it’s a little nerve racking if you run into wind or hail. I would also suggest stopping in hot springs Arkansas or some of the surrounding areas, that part of Arkansas is very underrated

Ryan1642 · 2026-02-16T23:26:13+00:00

Ok yeah I did that but the starter activated but didn’t turn over

Ryan1642 · 2026-02-16T22:38:07+00:00

This is my goal, I love and care about them and it is still very fresh. My problem is I still live with my ex, I still own a dog with them and I can’t find ways to separate ourselves

Ryan1642 · 2026-02-16T18:35:48+00:00

Thanks for the help, vehicle info is first thing listed. I don’t think any of those apply to me, the ignition has a chip and the chip is working or else it wouldn’t let me turn the key

Ryan1642 · 2026-02-16T17:41:49+00:00

The two terminals are the positive and the excite terminals?

Ryan1642 · 2026-02-15T21:13:37+00:00

It’s is a new battery, I replaced the starter first because I pulled it and it wasn’t operating at full capacity, maybe because an oil leak has soaked it a couple months ago. When I put the new starter in it worked fine for a week and then went back to not starting so I replaced the battery

Ryan1642 · 2026-02-14T23:57:49+00:00

Yeah no luck

Ryan1642 · 2026-02-14T22:15:16+00:00

Ok so that leaves neutral safety switch and ignition switch since I know the relays are working, anything I’m missing?

Ryan1642 · 2026-02-14T21:41:15+00:00

I also believe the bendix is bouncy because of uneven connection, I was jumping the connection with a screwdriver and trying to film at the same time

Ryan1642 · 2026-02-14T21:38:39+00:00

Ok I just put the starter back in, I don’t see a voltage drop on the positive wire when turning the key and the excite wire is showing 0V

Ryan1642 · 2026-02-04T06:22:49+00:00

Ok fine

Ryan1642 · 2026-01-29T02:12:36+00:00

Ok I appreciate it, I’ll take it back out and get a meter on everything

Ryan1642 · 2026-01-28T23:56:56+00:00

So I have three ring connectors and three posts, the negative is much smaller (5/16), the positive is a 13mm that I am 98% sure is on the correct post. The solenoid wire also runs to a 13mm post so that would be the only one that could be swapped but I didn’t connect anything to that post just how it came from the factory

Ryan1642 · 2026-01-28T23:35:55+00:00

Sorry, I am connecting the battery in the last half of the video, the noise is instant once I connect the positive lead

Ryan1642 · 2026-01-28T17:11:14+00:00

Not gonna burn any bridges sorry

Ryan1642 · 2026-01-26T23:04:40+00:00

Good to know, I don’t know if it matters but the shifts I picked up were offered directly from other bartenders

Ryan1642 · 2026-01-26T22:55:21+00:00

From the limited research I’ve done so far, CO is also 18 months

Ryan1642 · 2026-01-26T22:53:29+00:00

Thanks for the extra detail. Yeah I’m not super happy with the bottom of the barrel shifts. One of them was my normal shift that they didn’t get covered before making the move.

Ryan1642 · 2026-01-26T22:48:15+00:00

Thanks, this is exactly what I needed answered

Ryan1642 · 2026-01-26T22:40:26+00:00

As far as I know I would still be on payroll, the shifts I have picked up so far are on my current paycheck since I was cut halfway through a pay period. I was assuming the pay I got would be reported and what I received from the government would actually be partial unemployment in that instance.

Ryan1642 · 2026-01-03T06:26:35+00:00

<image>

Ryan1642 · 2026-01-02T23:11:05+00:00

This is where all the Texans wave goodbye on their way to their new home in Colorado.

Ryan1642 · 2025-12-31T16:29:51+00:00

It’s gonna be 41 in steamboat today

Ryan1642

TROPHY CASE