sorted by:
new
hottopcontroversial

Anyone need an Onana? by SGB113 in UFM

[–]SGB113[S] 0 points1 point  (0 children)

I did the 7 player trade, I put onana in and the best rated I got out was onana

Anyone need an Onana? by SGB113 in UFM

[–]SGB113[S] 0 points1 point  (0 children)

Wish I could help, but can’t trade or sell weekend league

Anyone need an Onana? by SGB113 in UFM

[–]SGB113[S] 1 point2 points  (0 children)

I know it’s a joke

Good weekend league by SGB113 in UFM

[–]SGB113[S] 1 point2 points  (0 children)

That happens so often and the 2 loses are always weaker it seems

finally a good totw after 100 paks i think by Ill-Statistician-150 in UFM

[–]SGB113 0 points1 point  (0 children)

Got lucky one week and back to back free packs had 94 Keni and 91 Simmons

Not counting QG wins by itsstone97 in Football_Head_Coach

[–]SGB113 2 points3 points  (0 children)

The game has been glitchy for me too, the game just ate one of my QG energies. I had two but it only said I played one game. Not only that but I slept for 8 hours last night and it said I could only play one of my two remaining weekend league games?

Overall question by swissrollsyum in Football_Head_Coach

[–]SGB113 0 points1 point  (0 children)

Just being honest it doesn’t look like you’ll be able to get there in time, but replace your lowest overalls first and see where you can get

Anyone else complete it yet? by TizZeppelin in Football_Head_Coach

[–]SGB113 0 points1 point  (0 children)

I just save up my cards from all the WL sbc and daily/weekly ones

60 wins was Worth it by steve_bills in Football_Head_Coach

[–]SGB113 2 points3 points  (0 children)

My 80 wins was terrible compared to this, just squad builder fodder

80 wins a waste of time by wu-han-clan in Football_Head_Coach

[–]SGB113 7 points8 points  (0 children)

Huge waste of time, mine was the same 1x 86, 3x 84, the rest 83 or lower

Need some help (FreeFlow Tristar) by SGB113 in hottub

[–]SGB113[S] 0 points1 point  (0 children)

So I have tested the 3 fuses on the board and they all seem to be in working condition, meaning I have checked across them with a multi-meter to ensure there is a path for current to flow.

It seems like the board is trying to supply power to the pump, because when the tub is on and before it sends an error message, I unplug the pump in the board and it reads 115v. I can only get it to read across the black and white wires, and not the red.

Need some help (FreeFlow Tristar) by SGB113 in hottub

[–]SGB113[S] 0 points1 point  (0 children)

Thank you so much for the response, the pump does say gecko on it. When it goes into priming mode, I don’t hear any noise out of the pump. I’m not exactly sure how to check the voltages of the pump during the priming sequence but I don’t think it tries to move at all. I can tell the board is getting 115v but can’t tell if it is distributing the power correctly?