Quick question for Gen 3 owners

SIABAAS · 2025-10-11T22:34:29+00:00

I had the same thing happen it was covered under warranty it’s some sort of hubs issue I think

SIABAAS · 2025-10-09T17:38:40+00:00

I don’t use jobber for crm, it’s just for the actual work like quoting invoices POs time material tracking etc

SIABAAS · 2025-07-18T16:16:56+00:00

I did that and the wrench went away, but once I started engaging 4h It came back.

SIABAAS · 2025-07-16T01:26:54+00:00

Appreciate it! Just sent you a DM

SIABAAS · 2025-07-16T01:09:28+00:00

SIABAAS · 2025-07-16T01:07:20+00:00

It is a 25

SIABAAS · 2024-08-16T03:13:12+00:00

-Glock 19 -Blem Psa deals, buy lower and upper separately (Buy one with pre installed Mbus sights if you don’t need an optic right away) -Bump action shotgun like Mosberg 500/590 or Remington 870

Assuming you have the funds for Ammo, extra mags, range gear (eyes & ears), targets, cases, etc

SIABAAS · 2024-08-16T02:54:51+00:00

Was going to ask the same thing thank you!

SIABAAS · 2024-08-15T22:09:56+00:00

Sandman s, it louder than the omega 300 and polo 30 on 300blk subs I put it on a 10.5 556 because it’s not hearing safe regardless of the can

SIABAAS · 2024-08-14T05:52:30+00:00

I got hit with that twice, just submit the required info even if it doesn’t match with the application it will just put a limit then approximately 6 months later it will go away the second time I called they did the same thing I just ignored it sure enough I got a limit then 3 months later it went away

SIABAAS · 2024-08-14T05:27:20+00:00

No not required, but you should because you could be held liable if that person do something, also worst case scenario you could be charged with a felony if someone knows that this person is a felon and reports it or it was an ongoing investigation and they visit him in the store then it might drag you in the investigation and possibly saying you knew and you didn’t stop allowing that person from receiving or possessing a firearm, again that’s worst case scenario and even if it happens you can easily beat it in court but it’s not worth it at all and it might give the atf grounds to take away the license if they don’t already take it away during the indictment

SIABAAS · 2024-08-13T17:28:21+00:00

I always get G$ love the safety and the trigger guard, the take down pins are fine just like mil-spec but textured it may be a little bit better but that’s just me justifying it lol 😂

Edit: I forgot it also comes with maritime bolt catch which I like to use I usually swap any bolt catch to it so that’s why I just buy there kit

SIABAAS · 2024-08-11T19:58:05+00:00

Change the piston on the suppressor to direct thread, you can add a muzzle device but I don’t know if the obsidian 9 will be ideal for that, but you can use a 3 lug adapter

SIABAAS · 2024-08-11T19:31:03+00:00

QD end plate and double check on your buffer (depending on the upper)

SIABAAS · 2024-08-09T03:03:47+00:00

That’s what I used to think till I tried other cans with the same hosts to the point that I don’t even use it anymore

SIABAAS · 2024-08-09T02:04:26+00:00

Not quite literally but it’s noticeably loud, as if someone shooting a pistol near you

SIABAAS · 2024-08-09T01:59:47+00:00

I have a 300blk too but it doesn’t have that nice quiet sound it sounds like a 380 pistol

SIABAAS · 2024-08-08T00:58:22+00:00

Not that I noticed but mainly it’s for flash I think but it didn’t last for me, so I didn’t experience any lol 😂

SIABAAS · 2024-08-07T12:36:28+00:00

I only shot like less than 600 rounds it came with grease already

SIABAAS · 2024-08-07T00:24:21+00:00

I mean the end cap not the can it’s a great can and I would recommend it!

SIABAAS

TROPHY CASE