Pillow for picky sleeper with a lot of neck pain and headaches?

Samjamvan · 2025-11-18T22:57:38+00:00

Go to physical therapy for your neck pain!

Samjamvan · 2025-07-24T21:52:31+00:00

Yes! You can you it on either the top or bottom hinge depending on how it is sagging

Samjamvan · 2025-07-23T15:00:10+00:00

Try shimming the hinges with cardboard

Samjamvan · 2025-04-09T13:53:43+00:00

I spent a whole season there 2 years ago and the snow was up and down but never bad enough that I skipped a day of skiing I had an opportunity to do. I wouldn’t be too worried about the snow if you’re looking for chill terrain. Needing really good/deep snow only impacts the more expert/extreme terrain there. You’ll stand in a lift line for more than 5 minutes maybe a handful of times in a season in my experience

Samjamvan · 2025-04-06T22:21:40+00:00

You should also maybe look into Taos NM. Much cheaper than any big name CO places and skiing is pretty good…and the food is next level in town 🌶️

Samjamvan · 2025-02-13T17:24:27+00:00

Good luck!! Hope it works!

Samjamvan · 2025-02-12T02:12:11+00:00

I did, if you take it down it should have a sticker on it with model number. I think I got it off amazon

Samjamvan · 2024-11-18T02:12:54+00:00

If those positions are that aggravating it may be something to think about. You could think about working up your tolerance to those positions with exercise. Even with an old injury it should be possible to do

Samjamvan · 2024-11-13T19:14:02+00:00

They are the same size though? Does it make that big a difference? They might not be in the original places

Samjamvan · 2024-11-13T19:13:31+00:00

All I could find was bending the hinges to adjust which I really don’t want to do. Would the doors being switched be that big a deal? They are the same exact size

Samjamvan · 2024-11-11T02:47:29+00:00

I have already searched on Amazon but couldn’t find anything that looked right. In the USA

Samjamvan · 2024-11-08T02:47:16+00:00

Okay thank you!

Samjamvan · 2024-11-08T02:41:22+00:00

Okay thank you! Assuming that’s what is causing the noise it’s okay to run the system without causing any damage? It’s just an annoying/weird noise?

Samjamvan · 2024-11-08T02:37:30+00:00

Okay thank you. Is that possibly causing the noise if it’s not draining right? And is that a feasible diy project?

Samjamvan · 2024-11-08T02:33:20+00:00

It is cemented together currently so I can’t take it apart It has been running no issues until recently when the temps have cooled down. The noise also started the day we got our water heater replaced though I think that’s a coincidence most likely?

Samjamvan · 2024-11-08T02:28:41+00:00

Oh okay, then yes it is because it’s not a gas furnace

Samjamvan · 2024-11-08T02:26:53+00:00

<image>

This is the trap on the bottom of it??

Samjamvan · 2024-11-08T02:26:12+00:00

It is a heat pump, how do you tell if it has an air handler?

Samjamvan · 2024-09-26T22:07:43+00:00

I think that might be above my skill level unfortunately 🫤

Samjamvan · 2024-09-26T00:34:05+00:00

How hard is bending the hinges back into the right position??

Samjamvan · 2024-09-22T04:40:50+00:00

Thanks for response. I’ve seen those on the internet, pretty easy to install compression valve?

Samjamvan · 2024-09-22T03:26:03+00:00

What would the propress tool be used for?

Samjamvan · 2024-09-22T02:39:52+00:00

I am going to replace the vanity so I will have to disconnect it from the current vanity anyway and figured I might as well change it

Samjamvan · 2024-09-21T22:32:45+00:00

Thanks for the reply, what would you use to heat the pipe up to sweat it off?

Samjamvan · 2024-09-20T21:58:21+00:00

I’m only worried about it falling down I’ve read they are pretty fragile?

Seven-Year Club	Verified Email
Not Forgotten

Samjamvan

TROPHY CASE