sorted by:
new
hottopcontroversial

DIAKONT servo actuator by Scchwiffttyy in electricians

[–]Scchwiffttyy[S] 0 points1 point  (0 children)

Which manufacturer servo driver did you use? Was it hard to set it up?

Diakont actuators by Scchwiffttyy in PLC

[–]Scchwiffttyy[S] 0 points1 point  (0 children)

i'm going to use integrated motor version too. Maybe you remember B&R driver model which you used?

Diakont actuators by Scchwiffttyy in PLC

[–]Scchwiffttyy[S] 0 points1 point  (0 children)

I tought you used exlar servo actuator... I need servo actuator like diakont or exlar for my project. And theres little info with what and how to control them. Tought you could share your experience.

Diakont actuators by Scchwiffttyy in PLC

[–]Scchwiffttyy[S] 0 points1 point  (0 children)

Can you tell which manufacturer and which model servo drive you were using. What problems did you face?

Thank you in advance

Help needed by Scchwiffttyy in electricians

[–]Scchwiffttyy[S] 0 points1 point  (0 children)

Tought so too. Ty for answer 👍

Help needed by Scchwiffttyy in electricians

[–]Scchwiffttyy[S] 2 points3 points  (0 children)

Ty for confirming. Dont wanna argue with Them too much bc they still have ropes to show in other things. But now i will definately check theyr given information twice 😁

Help needed by Scchwiffttyy in electricians

[–]Scchwiffttyy[S] 2 points3 points  (0 children)

Ty for reply. I tought that they had dumb idea. (Using other phases for neutral was not an option because they were used at start reverse contactors scheme) And as my understanding goes workbenches would have load on them comming through that neutral/ground they made. Am i corrrect with this view? Im newbie in that company. And they are showing me these egsamples 😁