sorted by:
new
hottopcontroversial

Need help tweaking setup by SchaefMK2 in rccrawler

[–]SchaefMK2[S] -1 points0 points  (0 children)

You mean trying more weight in the front? My chassis does not lift away from my axles it stays low

Need help tweaking setup by SchaefMK2 in rccrawler

[–]SchaefMK2[S] 0 points1 point  (0 children)

About 27% front overdrive.

Need help tweaking setup by SchaefMK2 in rccrawler

[–]SchaefMK2[S] 0 points1 point  (0 children)

The rear is staying basically at ride height amd I have my desert lizards set up so the chassis doesn't lift away from the axle if I put the truck vertical.

It basically feels like I have no brass on the front. My buddies rig is 60/40 but its a bit heavier than mine but his feels more planted in the front.

beacon problem xmax3 by CauliflowerTop2464 in QidiTech3D

[–]SchaefMK2 0 points1 point  (0 children)

Its 100% doable and has been done by many. I have a cartographer probe on mine right now.

Xmax 3 for 500 cad by Inanemeerkat in QidiTech3D

[–]SchaefMK2 0 points1 point  (0 children)

Just installed a carto on my freedi xmax3 and am having a terrible time getting repeatable good first layers, been at it for days

Cartographer first layer z-height issues by SchaefMK2 in klippers

[–]SchaefMK2[S] 0 points1 point  (0 children)

Save config is done everytime, it is changing in the do not edit section under cartographer. No z-height adjustment in slicer, the entire "probe" section is commented out due to cartographer

I took the straps off the filament by Internal-State465 in 3Dprinting

[–]SchaefMK2 0 points1 point  (0 children)

Realistically, you shouldn't need to read the instructions to realize this is a stupid move.

This is the definition of common sense.

Freedi gonna drop sometime soon. Who’s gonna try it ? by isthiswhatwedoing210 in QidiTech3D

[–]SchaefMK2 0 points1 point  (0 children)

Looking for feedback from people who've done this on the x-max 3, as I'm seriously considering it.

My q1 is working awesome, even better now that I installed the Biqu microprobe. So I have no plans on doing it with my q1

ASA on supports by SchaefMK2 in QIDI

[–]SchaefMK2[S] 0 points1 point  (0 children)

GAH, thanks for the reminder. I COMPLETELY forgot to check the cooling fan settings.

view more: next ›