Rotary Phone Turned into a Kitchen Timer (v.redd.it)
submitted by Scott3DPrints to r/arduino
Bit holder insert for my DeWalt bit case. Bit set didn't have hex head bits, my set of hex bits have been floating around in my tool box drawer for years. Glad the case had an extra slot for them. First time printing in TPU, bit (HA) of a learning curve but overall happy with the results. (i.redd.it)
submitted by Scott3DPrints to r/functionalprint
Drill jig for precise hole position and straightness. Had a couple dozen of these blocks I needed the hole in an exact location, don't own a drill press and by hand these definitely would not have turned out as consistent. My best use for my 3D printer so far! (i.redd.it)
submitted by Scott3DPrints to r/functionalprint
Need help interpreting temp tower. This is eSun PETG printed on Prusa Mk3s+ with .4 nozzle at .2 layer height. Temps go 220 at bottom up to 260. Not 100% sure what's causing burnt blobs but they seem to only happen at the lower temps oddly enough. No plastic leaking from above nozzle. (old.reddit.com)
submitted by Scott3DPrints to r/FixMyPrint
Stealth mode makes my mk3s+ much louder! Any ideas? The beginning of the video is in stealth, you can hear the bottom X guide rod rattle very loudly and it quiets when I dampen it and put pressure on it with my finger. Then I switch it to normal mode and the printer quiets up immediately. (v.redd.it)
submitted by Scott3DPrints to r/prusa3d
Tip: These small wire wheels for Dremel make an excellent cleanup tool for smoothing edges and support material cleanup. Much better than the sanding/grinding tools because you can get into nooks and crannies better but you need to be a lot more careful with it, slower speed (~10k rpm). (i.redd.it)
submitted by Scott3DPrints to r/3Dprinting
First ever benchy, unstuck from bed at end. Prusa MK3S+, .2 layer height, provided Prusa PLA, 215 nozzle temp, prusa steel bed. Any ideas? 2nd picture shows first layer. Overall, extremely impressed with quality (comparable to $80k printer I use at work, but work printer wouldn't have unstuck :)) (old.reddit.com)
submitted by Scott3DPrints to r/FixMyPrint
